Kenmore 625.348670 HOW Your Water Softener Works Faceplate Timer Features, Program Memory

RECHARGE TIME REMAINING

8

7 Bkwsh Rinse

6

5

4

3

2

1

MIN

Brine

SALTSIGNAL Serv

LEVELLEVEL

Fill

One of the valve position indica- tors (Serv, Fill, Brine, Bkwsh,

Rinse) is displayed while the softener is recharging (See

*NOTE on page 10 if the CLEAN feature is set to ON). RE- CHARGE flashes in the display

and, beginning with Brine, the minutes of recharge remaining before return to service appears in place of the present time. When the valve is moving from one cycle to another, both position indicators are flash- ing.

valve position indicators

recharge

time

remaining

VALVE

RECHARGE TIME REMAINING POSITION INDICATORS

and

AVG. DAILY GALLON

Press the #2 SELECT button again to show the average num-

ber of gallons of soft water the household uses each day. This water usage figure is adjusted daily by the faceplate timer. To turn this display off, press the #2 SELECT button once more.

8

7

6

5

4

3

2

1

AVERAGE DAILY GALLONS or LITERS

PM

SALTSIGNAL

LEVELLEVEL

FLOW RATE

WATER

To light the inside of the salt storage tank, press the TANK LIGHT button on the faceplate. Press the same button again to turn the light off, or it will go off automatically in 4 minutes.

TANK LIGHT

OTHER FEATURES

SECTION 2

2A.

HOW YOUR WATER SOFTENER WORKS

FACEPLATE TIMER FEATURES

						LOW SALT INDICATOR LIGHT
						When on, you need to refill the salt storage area with
						salt. After refilling, reset the salt monitor to turn the
	SALTSIGNAL
	LEVELLEVEL				PM
	8					light off. Refer to Salt Monitor System, page 10.
	7
	6
	5
	4					PROGRAM MEMORY
	3
	2
	1					If electrical power to the softener goes off, the time
		TANK
			tank light ON			display is blank but the faceplate timer keeps the
						correct time for about 48 hours. When electrical
				indicator
FLOW RATE THROUGH SOFTENER						power comes on again, you have to reset the present
						time only if the display is flashing. The HARDNESS
To view the gallon (or liter) per minute water flow						and RECHARGE TIME never require resetting
rate through the softener, if not already displayed,						unless a change is desired.
press the #2 SELECT button. If						Even if the timer is incorrect after a long power
soft water is being used, the flow
	SALTSIGNAL				PM
rate to the closest 1/10 gallon (or	LEVELLEVEL					outage, the softener works as it should to keep your
	8
liters) shows. If all faucets and	7					water soft. However, regenerations may occur at the
	6
	5					wrong time of day until you reset the timer to the
water using appliances are off,	4
	3				GPM
the display will show 0 flow.	2					correct time of day.
	1

ERROR CODE

An error code could appear in the faceplate display if aproblem occurs in the softenerelectronics. If you see an error code instead of the present time of day, please call you local Sears Service De- partment for service.

SALTSIGNAL LEVELLEVEL

8

7

6

5

4

3

2

1

12