Kenmore 625.34847 warranty Please see page 9 for Salt Filling DiRECTiONS

3A. SALT...REFiLLING STORAGE TANK/BREAKING A SALT BRIDGE

WHEN TO REFILL WITH SALT: Check the salt level a few weeks after' you install the softener and every week after' that, Refill when the storage tank is about I13 full. Never let the softener use all the salt before refilling Without salt, you will soon have hard water:

IMPORTANT:

You will have a loss in softening capacity and

may get partly hard water if less than 10

inches of salt is in the storage tank.

PLEASE SEE PAGE 9 FOR SALT FILLING DiRECTiONS.

SALT BRIDGE

Sometimes, a hard crust or salt bridge forms in the salt storage tank_ It is usually caused by high humidity or' the wrong kind of salt. When the salt bridges, an empty space forms between the water and salt. Then salt will not dissolve (melt.) in the water to make brine Without brine, the resin bed does not regenerate and you will have hard water.

If the storage tank is full of salt, it is hard to tell if you have a salt bridge_ Salt is loose on top, but the bridge is under it. The following is the best way to check for a salt bridge.

Salt should be loose all the way to the bottom of the tank. Hold a broom handle, or like toot, up to the softener as shown in FIG. 9. Make a pencil mark on the handle, 1" or 2" below the top height of the rim, as shown. Then, carefully push it straight down into the salt. If a hard object is felt before the pencil mark gets to the top of the tank, it's most likely a salt bridge, Carefully push into the bridge in a few places to break it_ Do not try to

break the salt bridge by pounding on the

outside of the salt tank. You may damage the tanl_=

If the wrong kind of salt was the cause of the bridge, take it out. Then fill the tank with nugget or' pellet salt only.

SALT BRIDGE

push tool into salt

bridge to break

•_ _ _ 2 _

J__

r-?

Pencil

Mark

J

Broom Handfe

14