Kenmore 625.34847 Automatic Electronic Diagnostics, Manual Initiated Electronic Diag, Nostics

AUTOMATIC ELECTRONIC DIAGNOSTICS

The face plate computer' has a self-diagnostic function for the electrical system (except input

power and water meter'). The £ t '=" .....

computer monitors the electronic {Fj% '= D_

components and circuits for cor- I

rect operation. If a malfunction occurs, an error code appears in the face plate display.

The chart below shows the error codes that could appear, and the possible defects for' each code

While an err'or code appears in the display, all face plate buttons are inoperable except the SEI_ECT button The SELECT button remains operational so the service person can make the Manual Initiated

Electronic Diagnostics to further isolate the defect, and check the water meter.

CODE

Err 01

Err 02

Err 03

Err 04

Err 05

	POSSIBLE	DEFECT
MOST LIKELY	_	_	LESS LIKELY

motor inoperative I wiring harness or connection to switch I position switch I face plate face plate

motor inoperative / face plate face plate / position switch face plate

PROCEDURE FOR REMOVING ERROR CODE FROM FACE PLATE: 1 Unplug tsansformer 2. Correct defect 3 Plug-in

transformer 4. Wait for 6 minutes, The error code will remm if the defect was not corrected

• , , , ,, ,, ........... ,,, , , ,, ,,,,,,,,,,,,, : -

MANUAL INITIATED ELECTRONIC DIAG-

NOSTICS

1.To enter diagnostics, press and hold the SELECT button until 000 - - shows in the display.

I TURB1NE SWITCHES]

nli='t,=.=_ l

orP

1

WATER METER (A) SWITCH (B)

A. The first 3 digits indicate water meter operation as follows:

000 (steady) = Soft water not in use, and no

flow through the meter.

--OPEN A NEARBY SOFT WATER FAUCET--

000 to 199 (continual) = Repeats display for each gallon of' water passing through the meter.

If you don't get a reading in the display, with the faucet open, pull the sensor' from the valve outlet port. Pass a small magnet back and forth in front of the sensor. You should get a reading in the display, if you get a reading, unhook the in and out plumbing and check the turbine for binding.

POSITION

SWITCH

I

I ..,....-TURBINE

..._--TURBINE SUPPORT AND

SHAFT

VALVE

OUTLET

B* The letter' (P) and dash (or dashes) indicate POSI- TION switch operation. If the letter' appears, the switch is closed, If the dash shows, the switch is

open.

Use the ON/OFF-HOLD (Recharge Now) button to manually advance the valve into each cycle and check correct switch operation.

20