![](/images/new-backgrounds/1040844/4084415x1.webp)
7. WIRING
1.Shut off the circuit breaker for the well system. Loosen the top screw housing cover. Flip the cover forward and remove to expose the control wires.
Electrocution hazard. For your safety, the information in this manual must be followed to minimize the risk of electric shock, property damage or personal injury. Properly ground to conform with all governing codes and ordinances.
2.The 12 gauge wire leads are
3.Wiring is similar to a traditional mechanical pressure switch. Two leads are connected to line supply, while the other supply the pump motor or starter. Wire the control to the line supply and pump motor or pump starter as required by the manufacturer's instructions. It is recommended that service switch be installed in addition to the circuit breaker. The disconnect for the controller must break all incoming power lines. This should interrupt line voltage and be installed near the
4.After completing the wiring, reattach the front cover by inserting the plastic tabs and snapping the cover into place. Tighten the top screw and ensure no loose wires protrude from the housing.
LINE | MOTOR | MOTOR | LINE |
BLACK | WHITE/STRIPE | BLUE | WHITE |
SCREW
TAB
TAB
8