Express® Lavatory System - |
|
Installation Instructions |
Installation Instructions continued . . .
Step 7: Connecting electrical and supply tubing
WARNING:
1.Insert the two sprayhead supply tubes into the two solenoid tube connectors by loosening the compression nut and firmly pushing the tubing into the connector until the tubes are fully seated, then
2.Connect the wires per the wiring diagram shown below.
3.Align the mounting screws with slots on the frame. Valve bracket slides down to lock into place.
4.Turn on the water supply to the
5.Turn on the electrical power, trigger the TouchTime® push buttons and check for proper function (the timing is electronically controlled and set at 15 seconds).
IMPORTANT: The Vernatherm™ valve is NOT
6.Check the temperature when approximately1.0 GPM water flow is reached and adjust if necessary (the range of the valve is
7.Reinstall panel to frame with the five
NOTE: Push button activation takes place only when released, (prevents “hold open” activation).
| TRANSFORMER |
|
|
|
|
| |
|
| COMPRESSION |
|
|
| NUT |
|
|
| B BLACK | G BROWN |
|
| LEFT GRAY |
|
| RED | LEFT GREEN |
|
| SUPPLY |
|
|
| TUBE |
|
|
|
| RIGHT GRAY | LEFT |
|
|
| |
|
| RIGHT GREEN | BUTTON |
|
|
| |
|
| LEFT | LEFT |
|
| GRAY | GREEN |
| GREEN |
|
|
| SUPPLY |
|
|
| TUBE |
|
|
|
| A BLACK | F BROWN |
| H BROWN |
|
|
| F BROWN |
|
|
| G BROWN |
|
|
| E BROWN | VERNATHERM |
|
| D BLACK | THERMOSTATIC |
|
| MIXING VALVE |
| |
|
|
| |
| C BLACK |
|
|
| B BLACK |
| RIGHT |
| A BLACK |
| BUTTON |
|
|
| |
Figure 7 |
| RIGHT | RIGHT |
| GRAY | GREEN | |
|
|
| |
12 | 2/8/07 | Bradley Corporation • |