| Express® Lavatory System - |
Installation Instructions | |
|
|
Installation Instructions continued . . .
Step 2: Rough in wall anchors and electrical outlet
IMPORTANT: Turn OFF electrical power to the outlet when installing the Express® Lavatory System.
1.Install a 110 volt GFI protected electrical outlet per local code at the location shown in Figure 2.
2.Install six 3/8" wall anchors with a minimum
NOTE: The dimensions for the wall anchors at location “A” are for reference only.
3.On the back of the bowl, measure the distance between the 3/4" bowl mounting holes. Divide this measurement in half. Measure and mark this dimension on the wall to the left of the centerline and to the right of the centerline. Install two 3/8" wall anchors with a minimum pull- out rating of 1,000 lbs. (supplied by installer) at the locations marked (ref. location “A” shown in Figure 1, 1a or 1b on pages
NOTE: The anchors will be used to mount the Express®
1/2" NPT HOT AND COLD SUPPLIES OR TEMPERED SUPPLY.
STUB OUT 2"
|
|
|
|
| ||
110 VOLT GFCI | ||||||
|
|
|
| |||
|
|
|
| |||
STUB OUT 2" |
|
|
|
| ELECTRICAL OUTLET | |
|
|
|
|
|
|
TRANSFORMER
LOCATION
Figure 2
Bradley Corporation • | 2/8/07 | 7 |