Express® Lavatory System - |
|
Installation Instructions |
Installation Instructions continued . . .
Step 5: Connecting supply
1.Loosen but do not remove the two mounting screws holding the valve bracket to the frame. Slide the valve bracket up until the larger cutout in the frame’s slot aligns with the screw head (see Figure 5b). Then lift up to remove the valve bracket from the frame.
2FOR HOT AND COLD SUPPLY: Attach the stop/check to the hot and cold water supply piping from the wall. Connect the flexible hoses to the Vernatherm™ Mixing Valve and to the check/stops (see Figure 5a).
NOTE: The “H” on Vernatherm™ Mixing Valve indicates hot water supply inlet.
FOR SINGLE TEMPERED SUPPLY: Attach the stop/check to the 1/2" tempered supply line. Connect the stop/check to the tempered line adapter with the flexible supply hose (Figure 5c).
3.Assemble the
4.Install the strainer on the drain plug opening inside the bowl, and push the strainer firmly into place. Secure the stainer with the screw provided.
Hot and
Cold
Supplies
VERNATHERM™ THERMOSTATIC
MIXING VALVE
FLEXIBLE SUPPLY
HOSE
Figure 5a
FLEXIBLE
SUPPLY
HOSE
CONNECT TO 1/2" NPT HOT WATER SUPPLY
CONNECT TO 1/2" NPT COLD WATER SUPPLY
VALVE BRACKET
MOUNTING SCREW
SLOT IN
FRAME
Figure 5b
Single
Tempered
Supply
Figure 5c
FLEXIBLE SUPPLY HOSE (TO SOLENOID BRACKET)
TEMPERED | TO SUPPLY LINE |
| |
LINE ADAPTER |
|
|
10 | 2/8/07 | Bradley Corporation • |