Motorola T3 Power Broadband manual MC-802 Wireless WallPlate, M2 Ethernet WallPlate Physical

System Description

M2 Ethernet WallPlate:

Physical

•5"(mm) x 3.5" (mm) x 1.25" (32mm)

•Operating Temperature: 0 - 40 degrees Celsius, 5% to 90% NC

•Operating Power: approximately 2W, line powered by the T3 Switch

Interfaces

•Uplink ports

oOne VDSL single wire pair port via RJ11 jack

•Downlink ports

oTwo 10/100Mb autosensing, full duplex Ethernet port via RJ45 jack

oOne pass-through filtered phone port via RJ11 jack

Layer-2 Networking Features

•802.1Q VLAN trunk ports

•802.1Q PVID per port

•QoS, 2 queues per port, port based classification

Management

•Embedded Layer-1 channel for device management from T3 Switch

MC-802 Wireless WallPlate

The MC-802 Wireless WallPlate has two 10/100Mb Ethernet ports, a pass-through RJ11 phone connector, and a managed 802.11b/g radio. It is installed at the end-point where Ethernet and/or Wireless service is desired. It operates over a standard 2-wire telephone line.

Features of the MC-802 802.11b/g radio:

Physical

•6.625"(168mm) x 3.75" (95.25mm) x 1.75" (44.45). lbs (Kg)

•Operating Temperature: 0 - 40 degrees Celsius, 5% to 90% NC

•Operating Power: approximately 6W, line powered by the T3 Switch

Interfaces

•Uplink ports

oOne VDSL single wire pair port via RJ11 jack

•Downlink ports

oTwo 10/100Mb autosensing, full duplex Ethernet port via RJ45 jack

oOne 802.11b/g radio

oOne pass-through filtered phone port via RJ11 jack

Layer-2 Networking Features

•802.1Q VLAN trunk ports

•802.1Q PVID per port

•QoS, 4 queues per port

Management

•Embedded Layer-1 channel for device management from T3 Switch

•Layer-3 IP addresses from private pool or public pool

•All management centralized on T3 Switch

Motorola, Inc. 570510-001-00 rev A Page 13 of 50