Motorola T3 Power Broadband manual Access Control Lists ACLs, Ip access-list config 1 deny http

Managing the Wireless WallPlates

Access Control Lists (ACLs)

Configure layer 3 ACLs based on an administrator defined IP addresses and pre-defined services. The pre- defined services are HTTP, FTP, Telnet, SNMP.

Number of ACLs:	20
Each ACL index:	IP address
	pre-defined service
	combination of IP address and service

ACLs are processed from index 1 through index 20. If no matches are found, the access is granted.

Place the most restrictive access rules on the lower index number.

To enter ACLs from the CLI, use the following command:

ip access-list config <1-20(index)> <denypermit(type)> [ip-address #.#.#.#] [mask #.#.#.#] [service allftptelnethttpsnmp]

Ex: To block all HTTP access from any device, enter:

ip access-list config 1 deny http

Ex: To block all network access from all devices except Telnet from a specific subnet, enter:

ip access-list config 1 permit ip-address 64.174.72.129 mask 255.255.255.128 service telnet ip access-list config 10 deny service all

Note: A 32-bit subnet mask will specify one single device with the specified IP address

Motorola, Inc. 570510-001-00 rev A Page 31 of 50