Aerada 1000/1100 Series | Installation |
D - Setting Scrub Mode (60 seconds)
Setting scrub mode for 60 seconds will allow the faucet to activate for 60 seconds from the last hand presence.
1Enable “Manual Setting” Mode
> see “Enabling Manual Setting Mode” section
2Fully cover sensor with hand. Water flow stops after 5 seconds - Continue to hold on for another three (3) additional water pulses.
3Remove hand.
Result: Scrub Mode is now activated for 60 seconds.
E - Setting Scrub Mode (180 seconds)
Setting scrub mode for 180 seconds will allow the faucet to activate for 180 seconds from the last hand presence.
1Enable “Manual Setting” Mode
> See “Enabling Manual Setting Mode” section
2Fully cover sensor with hand. Water flow stops after 5 seconds - Continue to hold on for another four (4) additional water pulses.
3Remove hand.
Result: Scrub Mode is now activated for 180 seconds.
F - Sensor Range Adjustment
The detection distance of the sensor can be adjusted between approximately 4 - 11 inches from the infrared window.
1Enable “Manual Setting” Mode
> See “Enabling Manual Setting Mode” section
2Remove all items from the sink.
2Fully cover sensor with hand. Water flow stops after 5 seconds - Continue to hold on for five (5) additional water pulses.
4Remove hand.
5Hold hand in the current detection area until LED flashes. Then move hand to the desired detection distance. When LED stays lit for two (2) seconds, detection distance has been
Result: The detection distance is now calibrated.
G - Reset
All settings will be reset to default setting. The “Manual Setting” Mode will be disabled.
>The procedure for the reset is the same as “Enabling Manual Setting Mode”, but step 5 needs to be done six (6) times in a row.
Result: All settings are reset to default settings and the
8 | 5/21/08 | Bradley Corporation • |