Eicon Networks 1530 manual Reset the Device

Step 7: Reset the Device

For your settings to take effect, you must reset the device by clicking the ‘Reset Device’ button at the top of the browser window.

‘Reset Device’ button

Notes:

•Normally you are returned to the welcome page after performing a reset. However, if the LAN IP address has been changed, you will lose contact with the Eicon 1530. If this is the case, you should receive an error message from your browser after about 45 seconds. To re-establish contact with the device, open the web configuration interface using the new IP address.

•If you changed the IP address of your computer in order to configure the Eicon 1530, you may need to return these settings to their original state.

•If you are using the Eicon 1530 as your DHCP server, you may need to restart your computer in order to acquire a new IP address from the device. If you are using Windows, you can do the following to acquire a new IP address without restarting:

Windows 95/98/Me: Click ‘Start’, ‘Run’, type ‘winipcfg’, and click ‘Enter’. Click ‘Renew All’.

Windows NT/2000/XP: Launch a command prompt, type ‘ipconfig /release’ and press Enter, then ‘ipconfig /renew’ and press Enter.

What’s Next?

See Step 8: Test WAN Access on page 23.

Setup 22