Eicon Networks 1530 manual General Commands

General Commands

HELP

Displays the general help on using the CLI.

SHOW CONFIGURATION

Displays a list of all the commands that define the current configuration and their current settings.

MONITOR

Invokes monitor mode. Monitor mode is used for uploading new firmware or for making a dump of system memory for debugging purposes. You can set the Eicon 1530 to automatically invoke monitor mode when a fatal error occurs with the SET ONERROR command.

PING Ipaddr [number] [size]

Lets you determine if an IP address is reachable.

Ipaddr: IP address of the device to PING.

number: Number of messages to send. Range: 1-no limit. Default: 4.

size: size of the message in bytes. Range: 1-1472. Default: 64.

RESET [FACTORY]

If no parameter is given, resets the Eicon 1530 using the current parameters.

If you specify FACTORY, this command resets the Eicon 1530 and returns all parameters to their factory default settings. WARNING: This command deletes all user-defined profiles, settings, and passwords.

HUB: Resets only the Ethernet Port.

LOGOUT

Closes the current configuration session.

SET ONERROR { HALT RESET }

Defines what should happen when a fatal error is encountered and the Eicon 1530 cannot continue to operate normally.

HALT: Activate monitor mode when a fatal error is encountered. The Power light will turn red to indicate that monitor mode has been activated.

RESET: Reset the device when a fatal error is encountered.

SAVE [profileName]

Saves the current configuration settings to non-volatile memory on the Eicon 1530. If a SAVE is not done, configuration changes are not kept after the device is reset or after the power is disconnected.

Command Line Interface 108