Eicon Networks 1530 manual SET IP Services ALL Intelligent Minimal None

SET IP SERVICES { ALL INTELLIGENT MINIMAL NONE}

Defines the level of support provided for Microsoft NetBIOS services, which are integrated into Microsoft TCP/IP. NetBIOS is required to support Microsoft Windows Network Neighborhood, the MAP NETWORK option in Windows Explorer, and various DOS-based networking commands (such as net use, net view, and net logon). Default: ALL.

ALL: All NetBIOS traffic is forwarded to the remote site. This may result in substantial connection charges unless you have a flat rate connection, as outgoing calls will be made frequently.

INTELLIGENT: Provides full support for all Network Neighborhood functions, but spoofs unnecessary traffic to reduce usage.

MINIMAL: Reduces NetBIOS traffic to a minimum. Does not support Network Neighborhood functions. However, the MAP NETWORK option in Windows Explorer is supported, along with DOS-based networking commands such as net use, net view, and net logon. This is the most economical solution.

NONE: All NetBIOS traffic is discarded.

ENABLE IP SPOOFING

DISABLE IP SPOOFING

Enables/disables spoofing. When enabled, all TCP keep-alive datagrams and all Microsoft Server Message Block datagrams are spoofed. In addition, all NetBIOS over IP name service traffic is dropped.

Default: Enabled.

ENABLE IP BROADCAST

DISABLE IP BROADCAST

Enables/disables support for IP broadcasting.

Default: Disabled.

ENABLE IP MULTICAST

DISABLE IP MULTICAST

Enables/disables support for IP multicasting. When disabled, IP multicast datagrams are not forwarded from the external network onto the internal Ethernet LAN. To allow computers on the internal LAN to subscribe to services that use IP multicasting as a delivery mechanism, you must enable this option.

Default for internal LAN: Enabled. Default for each profile: Disabled.

ENABLE IP MANUALDIAL

DISABLE IP MANUALDIAL

Enables/disables manual dialing of this profile. With manual dialing enabled, this profile will NOT be automatically connected when data needs to be sent. Instead, you must manually connect the profile. Use the DIAL command to dial the profile manually.

ENABLE IP UNNUMBERED

DISABLE IP UNNUMBERED

Enables/disables IP Unnumbered Mode for this profile. This saves an IP address by using the same IP address for both the external network and internal LAN. This option is valid only if NAT is NOT enabled.

Command Line Interface 139