IP Commands
SET IP ADDRESS Ipaddr
Defines the IP address for the Eicon 1530 on the Ethernet LAN it creates. By default, this address is set to 192.168.1.1, and you should not change it. However, if you are installing the Eicon 1530 on an existing LAN, you may need to change this value so that it is appropriate for your LAN setup.
SHOW IP ADDRESS
Displays the current IP addresses for the Eicon 1530. The addresses displayed might not be the same as those defined, but rather those as negotiated. For example, if an IP address is set to 0, it is negotiated to a new value when the connection is made. This command only displays the addresses that apply to the current profile, or all addresses if executed from the General context.
SET IP DESCRIPTION description
Defines the description for this IP interface (up to 39 alphanumeric characters).
SET IP MASK Ipaddr
Defines the subnet mask for the Eicon 1530 on the Ethernet LAN it creates.
Default: 255.255.255.0.
SET IP BACKUP profilename
Selects the backup profile to be used when this profile cannot connect. The backup profile is only invoked when the maximum number of connection retries has been exceeded, at which point a profile is set to a 'failed' state. The backup profile (if defined) is then used.
SHOW IP STATISTICS
Displays statistics for the IP protocol.
SHOW IP STATUS
Displays IP status information and all configured IP addresses.
SHOW IP CONFIGURATION
Displays IP configuration settings.
SET IP REMOTE Ipaddr
Defines the IP address of the remote device to which this profile connects. Use this only in cases when a static IP address is assigned to the remote site. In most cases, specify 0.0.0.0 to allow dynamic negotiation of the address when the connection is established.
Note: Dynamic negotiation is not supported by the LAN profile.
Command Line Interface | 138 |
