ENABLE PPP ECHOREQUEST
DISABLE PPP ECHOREQUEST
Enables/disables the use of PPP echo requests. Some systems do not properly respond to PPP echo requests. To connect to such systems, PPP echo requests should be disabled.
Default: Enabled.
SET PPP IDLETIME interval
Defines the idle timer for this profile, which controls how long a data call should stay connected when no traffic is being sent or received. When the idle timer expires, the call is disconnected.
Range:
Default: 120 seconds.This parameter automatically changes to 900 seconds when manual dialing (see page 139) is enabled.
SET PPP MAXRETRY number
Defines the maximum number of connection attempts this profile is allowed to make. When this limit is reached, the profile is placed in the ‘failed’ state.
To automatically reset the profile, use SET PPP RESTOREDELAY. To reset the profile manually, reset the Eicon 1530.
number: Number of attempts.
Range:
SET PPP RESTOREDELAY interval
Defines how long to wait before automatically restoring a profile from "failed" state to "ready".
Range:
Default: 300 seconds.
A profile fails if a connection cannot be established after the retry limit is reached (see SET PPP MAXRETRY).
SET PPP RETRYDELAY interval
Defines the amount of time in seconds to wait before allowing new attempts to connect. The default and range depend on the country.
Range:
SET PPP PRIORITY interval
When more than one profile attempts to connect using the same link, a profile with the higher priority will disconnect profiles with lower priority. For example, a profile with a priority of 0 will bump a profile with a priority of 2.
Range:
Default for all profiles: 0.
Command Line Interface | 144 |
