Eicon Networks 1530 manual Resetting the Device via the Reset Button

Resetting the Device via the Reset Button

The Reset button for the Eicon 1530 is shown below.

Front of Device Back of Device

Reset button

Normal Reset

If you press the Reset button once quickly, you will do a ‘normal’ reset. This reboots the device, and your settings are left intact.

You can also do a normal reset using the ‘Reset’ button at the top of the browser window when you are using the web interface.

Reset Settings to Factory Defaults

Warning: Resetting to factory defaults erases all configuration settings.

To reset to factory defaults, hold down the ‘Reset’ button for at least 15 seconds. The AUX light will turn on, then will go off after 15 seconds, indicating the reset is complete.

Note: This procedure will return the default IP address of the Eicon 1530 to 192.168.1.1. If you changed the IP address of the Eicon 1530 from this default setting, you will need to use the default IP address 192.168.1.1 to access the configuration menu.

You can also reset to factory defaults using the Web-based configuration interface (see Saving and Resetting Configuration Settings on page 36) as well as the Reset Factory command (see General Commands on page 108 for more information).

Entering Boot Monitor Mode

If you hold down the reset button for five seconds and less than 15 seconds, you will enter Boot Monitor mode, which is used for troubleshooting purposes only. Press the ‘Reset’ button once more to return the device back to normal operation.

Using your Eicon 1530 30