Eicon Networks 1530 manual Vhsi Port Configuration Commands

VHSI Port Configuration Commands

SET PORT PROTOCOL {PPP FRELAY X25}

Selects the protocol to be used on the VHSI interface.

PPP: Sets the VHSI interface to PPP.

FRELAY: Sets the VHSI interface to Frame Relay.

X25: Sets the VHSI interface to X25.

Note: Changing the VHSI interface deletes all currently defined profiles.

SET PORT DIALER {DIRECT V25BIS HAYES }

Defines the type of dialer the VHSI port should use when connected to a dial-up line (when SET PORT LINEINTERFACE is set to DIAL).

SET PORT LINEINTERFACE {LEASED DIAL }

Defines the type of line connected to the VHSI port.

LEASED: The port is connected to a null-modem cable or to a modem that links to a dedicated leased line.

DIAL: The port is connected to a modem that must be dialed in order to make a connection.

SET PORT DUPLEX {FULL HALF }

Defines the type of device the VHSI port is connected to.

FULL: The port is connected to a full-duplex device. This is the most common case and is

usually the choice for an X.25/QLLC connection. HALF: The port is connected to a half-duplex device. This is most often used on an SDLC connection.

SET PORT MULTIDROP {POINTTOPOINT MULTIPOINT }

Defines the type of line connected to the VHSI port: point-to-point or multi-point.

SET PORT CLOCKING {EXTERNAL INTERNAL EXTDPLL INTDPLL }

Defines how the VHSI port is clocked, which controls synchronization and the rate of data exchange on the line.

EXTERNAL: The port uses the clock supplied by the device it is connected to (DCE) for receiving and transmitting.

INTERNAL: The port generates an internal clock for receiving and transmitting, and outputs this clock on the interface for use by the device it is connected to (DCE).

EXTDPLL: The port employs a DPLL that uses a DCE generated clock at 32 (NRZI) or 16 (FM) times the data rate.

INTDPLL: The port employs a DPLL that uses an internally generated clock at 32 (NRZI) or 16 (FM) times the data rate.

Command Line Interface 140