Eicon Networks 1530 manual Displays Frame Relay configuration settings

SET FRELAY LMIT1 { 5 10 15 20 25 30 }

Defines how frequently the Eicon 1530 should initiate a Status Enquiry message. This timer must be set to less than the timer used by the Frame Relay Network to verify that the Eicon 1530 is sending Status Enquiry messages. To determine the Frame Relay Network timer value, contact your network administrator.

Possible values: 5, 10, 15, 20, 25, 30 (seconds).

Default value: Every 10 seconds.

SET FRELAY N1 fieldsize

Defines the maximum number of bytes of user data that can be contained in a Frame Relay frame.

Range: 19-4096.

Default value: 1514.

SET FRELAY WINDOWSIZE k

Defines the Frame Relay window size for all discovered DLCIs on a given Frame Relay connection, which determines the number of packets that can be sent before waiting for an acknowledgment. Only applicable if Dynamic DLCI is enabled. Used for transmission buffer control.

Range: 1-255.

Default: 2.

You can enable Dynamic DLCI using SET FRELAY DLCIMODE DYNAMIC.

SHOW FRELAY CONFIGURATION

Displays Frame Relay configuration settings.

SHOW FRELAY STATISTICS

Displays Frame Relay statistics.

SHOW FRELAY STATUS

Displays Frame Relay status.

SHOW FRELAY TRACE [mask [memsize [framesize]]]

Starts a Frame Relay trace, or displays an active trace.

mask:

01Data frame

02LMI frame

memsize: The amount of RAM reserved to store the trace on the Eicon 1530 WAN Router.

Range: 1-63 KB. Default: 16 KB

framesize: Number of characters to show for each frame.

Range: 64-1024 KB. Default: 128 KB

Note: If entered 0 or nothing the default value will be used.

STOP FRELAY TRACE

Stops an active Frame Relay trace.

Command Line Interface 128