Eicon Networks 1530 manual V25BIS Commands

V25BIS Commands

ENABLE V25BIS ANSWER

DISABLE V25BIS ANSWER

Enables/disables answering of incoming calls by the modem (DCE) connected the port. When enabled, the modem will automatically answer incoming calls.

SET V25BIS NUMBER { PRIMARY SECONDARY } Number

Defines the phone numbers to dial. The primary number is dialed first. If the primary is busy or otherwise non-responsive, the secondary number is dialed. If no secondary number is defined, the primary number is used again.

PRIMARY: The first number to dial.

SECONDARY: The number to dial if the primary is non-responsive.

number: the characters ‘CR’ followed by a prefix and the telephone number. The choice of prefix depends on the operation of the local Data Circuit-terminating Equipment (DCE). Normally, the N option is used. Note that the V.25bis DCE will not dial if one of these prefixes is not properly chosen. The following prefixes are available:

N: The primary telephone number for the modem to dial.

I:The primary number provided with an identification number.

S:The memory address to which the modem should refer. Example: SET V25BIS NUMBER PRIMARY CRN5551234.

SET V25BIS CONNDELAY ConnectionEstablishment

Defines the maximum delay permitted between dialing a number and a achieving a successful connection. This delay includes the dialing and handshake time between external modems. If this timer is exceeded, the call is abandoned.

Range: 15-65 seconds.

Default: 30.

ENABLE V25BIS RETRY

DISABLE V25BIS RETRY

Enables/disables the modem to redial, if the primary number is busy or otherwise does not respond. If you enable this option, the secondary number, if defined, will be redialed.

If the secondary number is not defined, the primary number will be redialed.

Default: Enabled.

SET V25BIS RETRY RetryLimit [RetryDelay]

Defines the dial retry settings.

RetryDelay: Delay before redialing.

Range: 0-65 seconds. Default: 5

Command Line Interface 122