Eicon Networks 1530 manual Ports and Indicator Lights, Amber Ethernet Light

Ports and Indicator Lights

Green Ethernet Light		Amber Ethernet Light	Power Connector
ON: The Ethernet cable is connected properly.		FLASHING: Data is being sent or
OFF: The Ethernet cable is not connected, or		received via the Ethernet cable.	Used for connecting
the wrong cable is connected (straight-through		OFF: Data is not being sent or	the Eicon 1530 to an
or crossover).		received via the Ethernet cable.	electrical outlet.
	Front of Unit		Back of Unit

			AUX Port
VHSI Port
			Auxiliary port (currently not used).
Used for connecting your
Eicon 1530 to the wide
area network.			AUX Light
			Shows the status of the
	VHSI Light		AUX port (currently unused).
			Also lights up to indicate the
	If you are using X.25:
			status of a factory reset (see
	ON: The X.25 layer is ready.		Reset Settings to Factory
			Defaults on page 30).
	FLASHING: The X.25 layer is not ready.
	OFF: The X.25 port is closed or the
	cable is disconnected.		Reset Button
	If you are using PPP:
	ON: The PPP layer is connected.		Used for resetting the Eicon 1530.
	FLASHING: The PPP layer is trying to		Pressing this button once resets
	connect to a remote site.		the device.
	OFF: The PPP layer is closed or the		Warning! All configuration settings
	cable is disconnected.		are lost if you hold down the Reset
	If you are using Frame Relay:		button for 15 seconds, which returns
	ON: The Frame Relay layer is		all settings back to factory defaults.
	connected.
	FLASHING: The Frame Relay layer is
	opening.
	OFF: The Frame Relay layer is closed or
	the cable is disconnected.			Power Light
		Ethernet Port		ON: Power adapter is properly connected.
				FLASHING: Device is in boot mode. If you
		Used for connecting to the Eicon 1530 to a
				are not upgrading firmware while in boot
		computer or LAN.
				mode, press the Reset button once to return
		A straight-through cable (the blue cable) is
				the device to normal.
		used for connecting to a LAN.		If you are upgrading firmware while in boot
		A crossover cable (sold separately) is
				mode, do not press Reset for at least one
		required to connect the Ethernet port		minute after transferring the firmware to the
		directly to a computer.		device.

Using your Eicon 1530 29