Eicon Networks 1530 manual PPP Commands

PPP Commands

ENABLE PPP ENCRYPTED

DISABLE PPP ENCRYPTED

Enables/disables encrypted password to be sent for authentication. If enabled, an encrypted password is used. This can only be used if the remote supports CHAP authentication. If disabled, unencrypted password is used and the remote can support either PAP or CHAP authentication.

Default: Disabled.

ENABLE PPP AUTHENT

DISABLE PPP AUTHENT

Enables/disables password authentication. When enabled, the Eicon 1530 WAN Router will authenticate the remote, using the username and password (encrypted/unencrypted) received from the remote.

Default: Disabled (Outgoing), Enabled (Incoming).

SET PPP LPASSWORD localPassword

Defines the password used when replying to valid authentication requests.

Range: 0-31 alphanumeric characters (no spaces). Default: eicon.

SET PPP LNAME localName

Defines the name used when replying to valid authentication requests.

Range: 0-31 alphanumeric characters (no spaces). Default: eicon.

SET PPP RNAME remoteName

Defines the name the remote device must supply when authentication is requested by the Eicon 1530.

Range: 0-31 characters, no spaces. Default: eicon.

SET PPP RPASSWORD remotePassword

Defines the password the remote device must supply when authentication is requested by the Eicon 1530.

Range: 0-31 characters, no spaces. Default: eicon.

ENABLE PPP COMPRESSION

DISABLE PPP COMPRESSION

Enables/disables PPP compression. When enabled, one of the following standards is automatically negotiated: Ascend, MPPC, MS-STAC, STAC 1, and STAC 3.

Default: Disabled.

Command Line Interface 143