American Standard 3636.STTS Cleaning and Maintenance, Construction debris from entering the drain

Page 2

3

After leveling base on subfloor, use base and mark studs. This will be the installed height of shower base. Mix the low-shrink bedding material (grout, mortar, plaster, etc.). Concrete is not recommended. Apply enough bedding material to support the entire bottom of the shower base. The bedding material must not be used under the apron (front edge).

Lift and lower base over center

Eof drain pipe and set into place

4 After the bedding material has been poured and before it sets,

lower the shower base into position with the drain assembly sliding over the waste pipe as shown in Fig. E. It will be necessary to "rock" the shower base until the top of the tile flange aligns with the lines drawn in Step 3 on the stud walls. Make certain the apron is contacting the rough floor along the entire length of the shower base. Insure that the base is level in two directions (see Fig. F). Snap strainer back into place and check for proper drainage.

Level

Level

CLEANING AND MAINTENANCE

Your American Standard shower base is designed to last indefinitely with reasonable care and maintenance.

The high-gloss acrylic surface is resistant to impact and retains its luster with proper care and maintenance. An integral, slip-resistant surface is incorporated for user safety.

General Cleaning: Do not use abrasive cleaners; a mixture of warm water and a mild liquid detergent is adequate for most cleaning. Strong detergents formulated for use on tile or porcelain-enamel surfaces should be avoided.

Caution: Do not allow liquid detergent containers to remain on base surfaces for more than a few moments. Do not use Lestoil, Windex, Mr. Clean, Dow Disinfectant (spray or concentrate), or Lysol Basin, Tub and Tile Cleaner. Do not allow nail polish remover, dry cleaning fluid, acetone, paint remover, or other solvents to contact acrylic surface.

AS AMERICA, INC. (“AMERICAN STANDARD”) ONE-YEAR

LIMITED WARRANTY

If inspection of this AS America, Inc. (“American Standard”) plumbing product, within one year after its initial purchase, confirms that it is defective in materials or workmanship, American Standard will repair or, at its option, exchange the product for a similar model.

This warranty does not apply to local building code compliance. Since local building codes vary considerably, the purchaser of this product should check with a local building or plumbing contractor to insure local code compliance before installation.

This warranty shall be void if the product has been moved from its initial place of installation; if it has been subjected to faulty maintenance, abuse, misuse, accident or other damage; if it was not installed in accordance with American-Standard's instructions; or if it has been modified in a manner inconsistent with the product as shipped by American Standard.

American Standard's option to repair or exchange the product under this warranty does not cover any labor or other costs of removal or installation, nor shall

American Standard be responsible for any other incidental or consequential damages attributable to a product defect or to the repair or exchange of a defective product, all of which are expressly excluded from this warranty. (Some states or provinces do not allow the exclusion or limitation of implied warranties, so this exclusion may not apply to you.)

This warranty gives you specific legal rights. You may have other statutory rights that vary from state to state or from province to province, in which case this warranty does not affect such statutory rights.

F

Level base in two directions.

For service under this warranty, it is suggested that a claim be made through the contractor or dealer from or through whom the product was purchased, or that a service request (including a description of the product model and of the defect) be sent to the following address:

Note: Allow the bedding material to completely harden before applying weight to the bottom of the shower base.

5

Tape over the strainer to protect the finish and prevent

 

construction debris from entering the drain.

Finish installation as shown in Figure H.

Tile

 

 

Waterproof

Cau

lk

Drywall

 

 

Tile

Adhesive

Stud

Shower

HBase

In the United States:

American Standard Brands

P.O. Box 6820

Piscataway, New Jersey 08855

Attention: Director of Consumer Affairs

For residents of the United States, warranty information may also be obtained by calling the following toll free number: (800) 442-1902 www.americanstandard.com

In Canada:

AS Canada ULC

5900 Avebury Rd.

Mississauga, Ontario

Canada L5R 3M3

Toll Free: (800) 387-0369

www.americanstandard.ca

In Mexico:

American Standard B&K Mexico

S. de R.L. de C.

Via Morelos #330

Col. Santa Clara

Ecatepec 55540 Edo. Mexico

Toll Free: 01-800-839-1200

www.americanstandard.com.mx

FOR AFTER-SALES SERVICE CALL 1 (800) 442-1902 WEEKDAYS.

© A S A m e r i c a , I n c . 2 010

752769-100 Rev. C

Image 2
Contents Models 3636.STTS, 3838.NEOTS, 4834.STTS Installation InstructionsTown Square Acrylic Shower Base 752769-100 Rev. CConstruction debris from entering the drain Cleaning and MaintenanceFinish installation as shown in Figure H
Related manuals
Manual 2 pages 19.06 Kb

3636.STTS, 3838.NEOTS, 4834.STTS specifications

American Standard has long been a leading name in bathroom fixtures, and the models 3838.NEOTS, 3636.STTS, and 4834.STTS exemplify the brand’s commitment to innovation, style, and functionality. Each of these models offers unique features and technologies that elevate the bathing experience.

The American Standard 3838.NEOTS is a testament to modern design and thoughtful engineering. This alcove tub measures 38 inches by 38 inches, making it suitable for smaller bathrooms without sacrificing comfort. One of its standout features is the durable acrylic construction, which not only resists stains and scratches but is also lightweight for ease of installation. The tub is designed with a silky-smooth surface that feels great against the skin. Additionally, the integrated lumbar support helps provide a more relaxing soak while the slip-resistant bottom enhances safety, making it an excellent choice for families.

Moving on to the 3636.STTS, this corner tub is specifically designed to maximize space in your bathroom. With its 36-inch dimensions, it fits snugly in corners, adding a stylish focal point to your bathing area. The 3636.STTS features a deep soaking design that immerses the bather, promoting ultimate relaxation. Its patented EverClean surface helps inhibit the growth of stain and odor-causing bacteria, ensuring a hygienic bathing environment. This model is equipped with a contemporary design that fits well with a variety of decor styles, making it a versatile choice.

Finally, the American Standard 4834.STTS model extends the brand’s philosophy of comfort and beauty. This spacious tub measures 48 inches by 34 inches, offering ample room for an indulgent soak. Its ergonomic design includes a sculpted backrest and armrests that provide optimal support, allowing you to unwind in style. The high-gloss acrylic finish not only enhances the aesthetic appeal but also ensures long-lasting durability. Additionally, this model is constructed with fiberglass reinforcement for extra stability and resistance to wear over time.

In summary, the American Standard 3838.NEOTS, 3636.STTS, and 4834.STTS models showcase the brand’s innovative approach to bathroom fixtures. Their combination of stylish design, user-friendly features, and durable materials make them outstanding choices for anyone looking to enhance their bathing experience. Whether you prioritize space-saving design, deep soaking comfort, or modern elegance, American Standard delivers quality and functionality in every tub.