Bose DXA2120 manual Source input, Output connections, Output 1 and Output

Page 14

4.0 Hardware Installation

4.7.3 PAGE source input

A microphone or another paging source can be connected to the PAGE INPUT jack using one of the following cable types.

 

 

T

RCA

S

S

T

 

 

 

 

PTT

 

 

2

 

1

2

XLR

3

3

 

1

 

 

 

 

PTT

 

 

T

 

T

R

Phone

R S

 

S

Plug

 

 

 

(Balanced)

PTT

 

 

 

 

T

Phone

T

S

Plug

 

S

 

 

(Unbalanced)

 

 

 

PTT

Normally

Open SwitchPTT (latching)

4.7.4 OUTPUT connections

Use the supplied 5-terminal connectors for wiring loudspeakers to the output jacks on the rear of the mixer/amplifier.

Screw terminal caps

5-terminal connector

Insert the speaker wire into the proper terminals for the type of voltage needed, as shown in the figure on the right.

Tighten the screws to hold the wires in place, and insert the screw terminal caps to cover each screw. These caps prevent making contact with the screws, which could cause an electrical shock.

WARNING: Terminals marked with are hazardous live. The external wiring connected to these terminals should be installed by an instructed person.

WARNING: Terminals marked with should be connected to the loudspeakers such that the metal parts of its terminal are inaccessible.

Follow the diagram below to insert the 5-terminal connector into the output jacks on the back of the mixer/amplifier.

Notice the proper wiring for 4 ohm, 70 volt or 100 volt uses. Both 70V and 100V wiring require the use of a jumper cable, as shown.

Note: Use 12 AWG (4 mm2) to 20 AWG (0.5 mm2) gauge wire for the jumper.

Rear connection panel

OUTPUT 2

OUTPUT 1

Input voltage switch

OUTPUT 1 and OUTPUT 2

4 Ohm wiring

70 Volt wiring

100 Volt wiring

14 of 36

Page 13 Page 15
Image 14
Page 13 Page 15
Contents FreeSpace DXA 2120 Digital Mixer/Amplifier Owner’s GuideSafety Information Please read this owner’s guideImportant safety instructions Contents Introduction Mixer/Amplifier accessoriesBose Volume Control User Interface Bose FreeSpace DXA 2120 Digital Mixer/AmplifierFront panel with compartment closed Hardware DescriptionFront panel with open compartment Rear panel Mixer Mode Operation Mode OptionsOperation mode options Stereo Select Mode Dual Mono Select ModeHardware Installation For one user interface 2000 ft 610 m max User interface accessoryUser interface installation For two user interfacesLine 1-4 source inputs System wiringSchematic for volume control user interface Direct source input Output 1 and Output Source inputOutput connections AC Power connection DC Power connectionSystem setup procedure System SetupSystem setup introduction Selecting an operation modeChoose Mixer Mode Mixer Mode settingsReminder the settings process Mixer Input Set-up Mixer Output Set-upMixer EQ Set-up Mixer Page In Set-up Mixer Direct In Set-up Mixer Master Vol Set-up Choose Stereo Select Mode Stereo Select Mode settingsRemember for adjustments, use three steps Stereo Select Input Set-up Stereo Select Output Set-upStereo Select EQ Set-up Stereo Select Page In Set-up Stereo Select Direct in Set-up Next Dual Mono Select Mode settingsChoose Dual Mono Mode Dual Mono Select Input Set-up Dual Mono Select Output Set-upDual Mono Select EQ Set-up Dual Mono Select Page in Set-up Dual Mono Select Direct In Set-up Overview of Utility Mode settings Choose Utility ModeUser Interfaces Mode user interface requirementsBose volume control with A/B select User interface useTroubleshooting Table Technical assistanceFactory Default Settings ReferencePro.Bose.com
Top Page Image Contents