Bose DXA2120 manual Mixer Input Set-up, Mixer Output Set-up

Page 18

5.0 System Setup

B

Mixer Input Set-up

Select each Input that has a source connected (1, 2, 3, & 4).

For Input Vol Lvl

For Input Bass Adj and Input Treb Adj

Adjust the value to +/-6 dB in increments of .5 dB.

For AGCEnable

Choose N (no) or Y (yes).

Note: AGC defaults to N. AGC is recommended for use with low-level sources (i.e. microphone with low sensitivity).

C

Mixer Output Set-up

Select each Output to be used (1, 2, or Auxout).

For Input Mix

Choose N (no) or Y (yes).

For Output Vol Lvl

For Output Bass Lvl

and Input Treb Lvl

Adjust the value to +/-6 dB in increments of .5 dB.

18 of 36

Image 18
Contents FreeSpace DXA 2120 Digital Mixer/Amplifier Owner’s GuideSafety Information Please read this owner’s guideImportant safety instructions Contents Introduction Mixer/Amplifier accessoriesBose Volume Control User Interface Bose FreeSpace DXA 2120 Digital Mixer/AmplifierHardware Description Front panel with open compartmentFront panel with compartment closed Rear panel Operation Mode Options Operation mode optionsMixer Mode Stereo Select Mode Dual Mono Select ModeHardware Installation For one user interface 2000 ft 610 m max User interface accessoryUser interface installation For two user interfacesSystem wiring Schematic for volume control user interfaceLine 1-4 source inputs Direct source input Source input Output connectionsOutput 1 and Output AC Power connection DC Power connectionSystem setup procedure System SetupSystem setup introduction Selecting an operation modeMixer Mode settings Reminder the settings processChoose Mixer Mode Mixer Input Set-up Mixer Output Set-upMixer EQ Set-up Mixer Page In Set-up Mixer Direct In Set-up Mixer Master Vol Set-up Stereo Select Mode settings Remember for adjustments, use three stepsChoose Stereo Select Mode Stereo Select Input Set-up Stereo Select Output Set-upStereo Select EQ Set-up Stereo Select Page In Set-up Stereo Select Direct in Set-up Dual Mono Select Mode settings Choose Dual Mono ModeNext Dual Mono Select Input Set-up Dual Mono Select Output Set-upDual Mono Select EQ Set-up Dual Mono Select Page in Set-up Dual Mono Select Direct In Set-up Overview of Utility Mode settings Choose Utility ModeUser Interfaces Mode user interface requirementsBose volume control with A/B select User interface useTroubleshooting Table Technical assistanceFactory Default Settings ReferencePro.Bose.com