Bose DXA2120 manual Dual Mono Select Input Set-up, Dual Mono Select Output Set-up

Page 27

5.0 System Setup

B

Dual Mono Select Input Set-up

Select each Input that has a source connected (1, 2, 3 & 4).

For Input Vol Lvl

For Input Bass Adj and Input Treb Adj Adjust the value to +/-6 dB in increments of .5 dB.

For AGCEnable Choose N (no) or Y (yes).

Note: AGC defaults to N. AGC is recommended for use with low-level sources (i.e., microphone with low sensitivity).

C

Dual Mono Select Output Set-up

Select each Output to be used (1, 2, or Auxout).

For Output Vol Lvl

For Output Bass Lvl and Input Treb Lvl Adjust the value to +/-6 dB in increments of .5 dB.

For Out 1 and Out 2 Input Sel

For Auxout Input Sel Selects which inputs are routed to the Aux output.

Input TrackWP tracks to A/B switch on user interface.

Note: If TrackWP is selected and a user interface is installed, the input (A/B) selected on the user interface will be displayed.

27 of 36

Image 27
Contents Owner’s Guide FreeSpace DXA 2120 Digital Mixer/AmplifierPlease read this owner’s guide Safety InformationImportant safety instructions Contents Bose FreeSpace DXA 2120 Digital Mixer/Amplifier Mixer/Amplifier accessoriesBose Volume Control User Interface IntroductionHardware Description Front panel with open compartmentFront panel with compartment closed Rear panel Operation Mode Options Operation mode optionsMixer Mode Dual Mono Select Mode Stereo Select ModeHardware Installation For two user interfaces User interface accessoryUser interface installation For one user interface 2000 ft 610 m maxSystem wiring Schematic for volume control user interfaceLine 1-4 source inputs Direct source input Source input Output connectionsOutput 1 and Output DC Power connection AC Power connectionSelecting an operation mode System SetupSystem setup introduction System setup procedureMixer Mode settings Reminder the settings processChoose Mixer Mode Mixer Output Set-up Mixer Input Set-upMixer EQ Set-up Mixer Page In Set-up Mixer Direct In Set-up Mixer Master Vol Set-up Stereo Select Mode settings Remember for adjustments, use three stepsChoose Stereo Select Mode Stereo Select Output Set-up Stereo Select Input Set-upStereo Select EQ Set-up Stereo Select Page In Set-up Stereo Select Direct in Set-up Dual Mono Select Mode settings Choose Dual Mono ModeNext Dual Mono Select Output Set-up Dual Mono Select Input Set-upDual Mono Select EQ Set-up Dual Mono Select Page in Set-up Dual Mono Select Direct In Set-up Choose Utility Mode Overview of Utility Mode settingsUser interface use Mode user interface requirementsBose volume control with A/B select User InterfacesTechnical assistance Troubleshooting TableReference Factory Default SettingsPro.Bose.com