Bose DXA2120 manual Stereo Select Input Set-up, Stereo Select Output Set-up

Page 23

5.0 System Setup

B

Stereo Select Input Set-up

Select each Input that has a source connected.

• For Input Vol Lvl

• For Input Bass Adj and Input Treb Adj Adjust the value to +/-6 dB in increments of .5 dB.

• For AGCEnable

Choose N (no) or Y (yes).

Note: AGC defaults to N. AGC is recommended for use with low-level sources (i.e., microphone with low sensitivity).

C

Stereo Select Output Set-up

Select each Output to be used (1/2 or Auxout).

• For Output Vol Lvl

•For Output Bass Lvl and Input Treb Lvl Adjust the value to +/-6 dB in increments of .5 dB.

• For Out 1/2 Input Sel

• For Auxout Input Sel Selects which inputs are routed to the Aux output. Input TrackWP tracks to A/B switch on user interface.

Note: If TrackWP is selected and a user interface is installed, the input (A/B) selected on the user interface will be displayed.

23 of 36

Image 23

Contents Owner’s Guide FreeSpace DXA 2120 Digital Mixer/AmplifierPlease read this owner’s guide Safety InformationImportant safety instructions Contents Bose FreeSpace DXA 2120 Digital Mixer/Amplifier Mixer/Amplifier accessoriesBose Volume Control User Interface IntroductionFront panel with compartment closed Hardware DescriptionFront panel with open compartment Rear panel Mixer Mode Operation Mode OptionsOperation mode options Dual Mono Select Mode Stereo Select ModeHardware Installation For two user interfaces User interface accessoryUser interface installation For one user interface 2000 ft 610 m maxLine 1-4 source inputs System wiringSchematic for volume control user interface Direct source input Output 1 and Output Source inputOutput connections DC Power connection AC Power connectionSelecting an operation mode System SetupSystem setup introduction System setup procedureChoose Mixer Mode Mixer Mode settingsReminder the settings process Mixer Output Set-up Mixer Input Set-upMixer EQ Set-up Mixer Page In Set-up Mixer Direct In Set-up Mixer Master Vol Set-up Choose Stereo Select Mode Stereo Select Mode settingsRemember for adjustments, use three steps Stereo Select Output Set-up Stereo Select Input Set-upStereo Select EQ Set-up Stereo Select Page In Set-up Stereo Select Direct in Set-up Next Dual Mono Select Mode settingsChoose Dual Mono Mode Dual Mono Select Output Set-up Dual Mono Select Input Set-upDual Mono Select EQ Set-up Dual Mono Select Page in Set-up Dual Mono Select Direct In Set-up Choose Utility Mode Overview of Utility Mode settingsUser interface use Mode user interface requirementsBose volume control with A/B select User InterfacesTechnical assistance Troubleshooting TableReference Factory Default SettingsPro.Bose.com