Instalaation
Completed installations of header bracket, door bracket with plate and door arm (depending on door type) are shown below.. The header bracket supports the front end of the Tee rail. The door bracket connects door arm to troltey,
IT IS RECOMMENDED THATTH E OPENER PERMITS. Follow only those instructions
BE INSTALLED 7 FEETOR MOREABOVE THE FLOOR WHERE SPACE which apply to your door type as shown on Page 5.
STEP 1 Install Door Bracket and Plate
TO PREVENT DAMAGE TO LIG HTWEIGHTGARAGE DOORS, ALWAYS REINFORCE THE INSIDE OF
BOTH VERTICALLY AND HORIZONTALLYMWITH 2x4 BOARDS OR ANGLE IRON.
Horizontal brace should be at least 6 feet tong Verticat brace should cover height of top panel. Reinforcement hardware is not supplied (See No t Below.) FASTEN SECURELY AS SHOWN BEFORE INSTALLING DOOR
BRACKET AND PLATE_
Sectional Door installation Procedure
With door closed, locate and markthe vertical center-
line of garage door. Extend line onto header wail above door.
1.Assemble door bracket and plate as shown Cen- ter bracket on vertical guideline (or up to one foot left or right of center if necessary)
2o Position bracket assembly on face of door within
Header :kel
L
Header
VerticalWall
LineI
Door Bracket &
P{ate Assy
the following limits: A. Top edge of bracket 2" to 4" below the top edge of door B. Directly below any structural support across top of door.
Placement depends on your particular needs
3.Mark and drill 5/! 6"TOP and BOTTOM fastening holes Secure bracket as shown
._ | Door | |
Carriage Bolt |
| |
|
| Bracket |
|
|
|
| Door Bracket |
|
| TOp of Door |
| Plate |
|
|
|
| Lock |
|
|
|
| Washer |
SECTIONAL DOOR | Door |
|
| 5/16" |
Arm |
|
|
| |
|
|
|
| |
| Board | for | Inside Edge | |
| Lightweight | Doors | of Door | or |
|
|
| Reinforcement | Nut |
|
|
| Board | |
|
|
|
|
All One-Piece Door installation Procedure
With door closed, locate and mark vertical centerline of door,, Extend line onto header wall above door
NOTE: The door bracket has left and right side fastening holes. Assemble door bracket and plate
if your installation requires top and bottom fas- tening holes. (Refer to illustration).
Center bracket (with or without plate as required) on top edge of door as shown Mark and dri]I two 5/16" fastening holes and secure door bracket. NOTE: if
door has no exposed framing, drill 3/16" pilot
holes and substitute 5/16" x
Lock Washer
5/16"5t16"-!8
Bracket
Door,Plate
Top Edge
of Door
(Outside) | - (Optiona!) |
Carriage Boil
NOTE: Door bracket may be installed on face of
door if required for your installation. (Refer to dotted line drawing). HOWEVER, drill 3/16"pilot
holes and substitute 5/16" x
Face of DOOr | Door Brackel | |
installation | ||
Plate | ||
| ||
Vertical | (Optional) | |
| ||
Center |
| |
Line |
| |
ONE PIECE DOOR |
|
lO