Removing, Installing, and Replacing Components
41
Installing a 3½” Internal Hard Disk Drive
Your system comes with an available bay to hold an additional 3½” hard disk drive. The drive you install must not require front panel access. The hard disk drive access light blinks when either internal drive is active.
!Before opening the system unit, save any open files, exit Windows, turn off the power of the computer and all attached peripherals, and then unplug the power cord.
1Configure the jumpers on the new drive as a primary slave (see your drive’s documentation for configuration instructions).
Power connector
Jumpers
Drive connector
KY0084.VSD
2Disconnect the power cord from the computer.
3Remove the cover (see “Removing the Cover” on page 22).
4Remove the four screws (A in next diagram) that secure the drive holder to the top of the chassis.