Sony PCV-R532DS manual KY0095.VSD

Page 55

Removing, Installing, and Replacing Components

47

8Secure the drive with four screws (provided with new drive). Do not overtighten the screws.

KY0095.VSD

9Attach the drive connector and power cable to the drive. Make sure the drive connector is connected securely to the motherboard.

10

11

12

Replace the cover (see “Replacing the Cover” on page 26).

Replace the front panel (see “Replacing the Front Panel” on page 25).

Reconnect the power cord and then turn on your computer.

Your computer automatically recognizes the new drive and configures itself accordingly when you turn it on. Format and partition the new drive following the instructions provided with the drive.

Image 55
Contents Page Owner’s Record Safety InformationRegulatory Information Telephone Consumer Protection Act FCC PartContents Vaio Digital Studio Reference Manual Removing, Installing, and Replacing ComponentsFax/Modem Card Link Card Cmos Setup Options Viii Chapter Identifying Components Front View Drive Description DrivesButton or switch Description Buttons and SwitchesIndicator Description IndicatorsConnector Description ConnectorsUSB Rear View IconDescription IconsTelephone for phone Link IEEE-1394 Serial Connector USB ConnectorsKeyboard and Mouse Printer Connector MIC Vaio Digital Studio Reference Manual Game ConnectorMIC, Line IN, and Headphones HeadphonesTelephone and Line Link IEEE-1394 ConnectorsExpansion Slots Chapter Configuring Your System Accessing the Bios Setup Utility Click Settings Changing the Displays Power Management SettingsVaio Digital Studio Reference Manual Configuring the System Board Page Chapter Removing, Installing, Replacing Components Removing the Cover Removing, Installing, and Replacing Components Removing the Front Panel Replacing the Front Panel Replacing the Cover Gently press the frame in until it clicks into position Installing an Add-In Card Removing an Add-in Card Vaio Digital Studio Reference Manual Replacing the Lithium Battery KY0072.VSD Removing, Installing, and Replacing Components Memory module configurations MB Installing System MemoryDIMM2 DIMM1 Vaio Digital Studio Reference Manual Removing a Memory Module Push out Removing a Slot Cover Covering an Open I/O Slot Installing a 3½ Internal Hard Disk Drive Slide the drive holder forward B, and then out Connect the second power connector to the new drive Vaio Digital Studio Reference Manual Installing a 5¼ Internal Hard Disk Drive Drive bay Drive bay cover KY0095.VSD Removing the Power Supply KY0097.VSD KY0098.VSD Replacing the Power Supply Page USB1 Chapter System BoardFront Panel Header J25 ConnectorsName Description Diskette Drive Connector Memory Module Dimm Connectors PCI Slot Connectors Power Connector IDE ConnectorsClock Keyboard and Mouse ConnectorsPin Data Logic GNDUSBP1 USB ConnectorsPin Signal Name USBVCC2USBVCC1 Serial 1, PRINTER, and Monitor ConnectorsUSBP0 Select AUTO-FEED DCD RXD TXD DTR Logic GND DSR RTS CTSStrobe Data BIT BusyHorizontal Sync Vertical Sync RED Green Blue GND DDC GND RED GND Green GNDFansen Fan ConnectorsGamevcc JPYB0 JOYA0 GND JOYA1 JOYA2 Game ConnectorHEADPHONES, Line IN, MIC Connectors CD-IN Connector Modem Connector AUX-IN Connector Configuration Jumper Chapter Fax/Modem Card Name Connector Type DescriptionTelephone Page Link Card Page Chapter Cmos Setup Options Vaio Computer Reference Manual Main Screen LBA CD-ROMLOW Advanced ScreenHigh MuteUswc EPP 2F8H/IRQ33E8H/IRQ4 3BCH/IRQ7Symbios Scsi Bios Cmos Setup Options Page Dpms OFF Power ScreenVaio Computer Reference Manual Atapi CD-ROM Boot ScreenAtapi MO Exit Screen Chapter Miscellaneous Technical Information If you set these passwords Following passwords are required About User and Supervisor PasswordsBeep Code Error Messages Message Meaning PCI Configuration Status and Error MessagesMiscellaneous Technical Information DMA Channel Assignments Default AssignmentChannel Address Range Description Hex System I/O Address MapVaio Computer Reference Manual Address Range Description Hex Memory Map Address range Default configurationSettings IRQ SettingsPCI Bus Chapter SpecificationsProcessor ChipsetL2 Cache Dimm ConfigurationsGraphics Communications AudioExpansion Slots Drives and Controllers System BiosROM Index IDE 104PCI 105Mouse 106