Working with the cutting and gra- ting discs

Hints:

•Cut the ingredients into approx. 3 cm size pieces before adding them to the bowl 9.

•The appliance chops the ingredients very fast, therefore allow the appliance to run only briefly.

•Do not allow the appliance to run for more than 1 minute at a time.

•Should the ingredients get caught up in the bowl

9 or between the blades z: - Switch off the appliance.

- Remove the lid 0 from the mixing bowl 9. - Remove the ingredients with a spatula o.

7.2Remove the cutting and grating blades from the accessory clip

•Remove the lid 2 from the blender jug 4 by turning it clockwise.

•Grasp the accessory clip 3

on the handle at the centre of the retainer 3 with the thumb and index finger.

•Pull the accessory clip 3 with the cutting and grating discs (I-VI) out of the blender jug 4.

• Remove the cutting and grating discs (I-VI) from the holder 3.

7.3Insert the cutting and grating discs back into the accessory clip

• Insert the cutting discs (II/III) in the retainer slots. Begin

with the inner retainer

slots.The lateral flaps with the

elevation in the middle must point upwards.

Make sure that all the cutting edges are pointing in- wards.

• Place the shredder (IV/V), grater (I) and potato-chips

disc (VI) in the storage slot on the outside.

• Place the accssory clip 3 back in the blender jug 4.

•Place the cover 0 on the li- quidiser 4 so that the arrows on the handle of the liquidiser 4 and on the cover 0 point towards each other. Turn the cover 0 anti-clockwise until it sits firmly.

7.4Working with the cutting and gra- ting discs

Caution:

•The cutting edges are very sharp! Exercise inser- ting and removing or cleaning the discs!

•Never use your fingers, spatula, spoon handles or similar objects for pushing foodstuff through the filling shaft q!

- 5 -