Kompernass KH 700 Working with the kneading blade, Place the lid 0 on the bowl

Page 8

The cutting (II/III) and grating discs (IV/V) can be used to slice or grate food stuffs quickly. The special potato-chip disc (VI) enables you to make uniform potato-chips at home. With the potato grater disc (I) you can finely chop raw potatoes for the mixture, and finely grate other vegetables or fruits as well.

•Place the mixing bowl 9 on the food processor. Select the appropriate disc.

•Place the disc with the lea- ding edge (the side without the ring marking on the cor- ners) in the disc holder i.

•Push the other side (marked with two circles at the cor- ners) down until the disc engages with a “click”.

•Fit the retainer r to the drive shaft 8. Insert thumb and in- dex finger in the holes of the disc holder i and place it on the retainer r.

•Place the lid 0 on the bowl

9.

•Set the speed controller 7 to level 3 (maximum speed) for cutting and grating. Should you wish to process soft fruit or vegetables you can also select a lower speed.

•Slowly and gradually push the ingredients in the filling shaft q using the pusher w.

•To remove the disc from the disc holder i, remove the disc from the disc holder i by pushing on the marked side in an upward direction.

Hints:

•Cut the food into pieces so that they fit through the filling shaft q.

•Fill the filling shaft q evenly and do not exert ex- cessive pressure.

•If you wish to process large quantities of food do it in small batches and empty the mixing bowl 9 inbetween.

7.5 Working with the kneading blade

With the kneading blade t you can knead bread dough and mix batter or cake mixture.

•Place the mixing bowl 9 on the food processor.

•Place the kneading blade t on the retainer r and fit on the drive shaft 8.

•You can now fill ingredients through the filling shaft q.

•Add the ingredients to the mixing bowl 9.

- 6 -

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Food Processor III Content Fitting the lidTechnical data Safety instructionsAppliance description Intended UseAssembling the food processor Fitting the mixing bowlFitting the lid Before starting the device ensure thatWorking with the mixing bowl Insert the ingredient by filling shaft and pusherWorking with the cutting blade Fit the mixing bowl 9 to the food processorWorking with the cutting and gra- ting discs Remove the cutting and grating discs I-VI from the holderWorking with the kneading blade Place the lid 0 on the bowlPlace the mixing bowl 9 on the food processor Add the ingredients to the mixing bowlWorking with the blender Cleaning & Care Wipe the housing with a clean, damp cloth after each useMalfunctioning During operation, proceed as followsWarranty and service DisposalImporter Case of doubt, please contact your waste disposal centreTable for ingredients
Top Page Image Contents