EMS2340 | English |
|
|
| GETTING STARTED |
Unpacking | Connecting to the mains |
N.B. When you unpack the oven, check that the product is free from damage. Damage or any missing parts must be reported immediately to the retailer. The oven, parts of the oven or the accessories may be wrapped by a protection foil. If so, you must remove this foil before using the oven. Do not leave packing material so that small children can play with it. This can be hazardous.
Installation
1.Remove any promotion label from the door.
2.Install the oven on a flat, level surface. The surface must be strong enough to safely bear the weight (17.5 kg) of the oven, and the contents. To avoid the possibility of causing vibration or noise the oven must be in a stable position.
3.Keep the oven away from heat and water. Exposure to heat and water can lower oven efficiency and lead to malfunctioning, so be sure to install the oven away from heat and water sources.
4.Do not block air vents on the top and the sides of the cabinet and also do not place any articles on the top of the oven. If air vents are blocked during operation, the oven may overheat, and this may lead to malfunctioning. Hot air escapes from the vents, so be sure not to obstruct it or let curtains come between the oven and the rear wall.
5.Place the oven as far away from radios and TV’s as possible. This oven does conform to EEC requirements* of radio interference suppression, but some interference may occur if it is placed too close to a radio or TV, so keep them as far apart as possible.
6.If positioned in a corner, leave a gap of at least 5,0 cm from the walls to meet ventilation demands.
Important! The oven can be placed almost anywhere in the kitchen. Make sure the oven is placed on a flat, level surface and that vents as well as the surface underneath the oven are not blocked (for sufficient ventilation).
*This appliance conforms to the requirements of EEC Radio Interference Directive 87/308/EEC.
The oven is delivered with the power cord and a plug for 230V, 50Hz, earthed socket outlet. Earth protection minimises the risks should a
N.B. If the oven is connected to the socket via an extension cord, make sure the cord is earthed.
WARNING! This appliance must not be used on a
Contact an electrician if you are uncertain regarding electrical connection of the oven or provision of earth protection of the supply.
This appliance must be earthed. If this appliance is fitted with a
Electrical connections
WARNING! THIS APPLIANCE MUST BE EARTHED.
The manufacturer declines any liability should this safety measure not be observed.
•If the plug that is fitted to your appliance is not suitable for your socket outlet, it must be cut off and the appropriate plug fitted.
•Remove the fuse from the cut off plug. The cut off plug should then be disposed of to prevent the hazard of shocks in case it should be plugged into a 13 Amp socket in another part of your home.
8