Dolby Laboratories DP572 user manual 2DP571 front and back panel

Page 34

Dolby E Multichannel Distribution System User Manual	DP571 Dolby E Encoder

		Remote
	Activity	4	8
	Channel	2 3	6 7
	Input	TCPCMDly 1	ErrorFault	VRemoteRef
			5
Config	3x2	8x1	6x1	Other
DolbyEProgram	5.1	5.1+2	5.1+2x1	4x2
OutputData	16bit	20bit	24bit	PCM
Status		Setup	Esc
Insert			Enter
Delete				Contrast
Remote			Shift

	20bit
	DolbyE 5.1+2

	E Encoder	DP571
	E Encoder	DP571
	Dolby	Model

ratingbeforeapplyingpower.	CAUTION	To reduce the risk of	fire replace only with	same type and rating	250V slow-blow fuse	100-240 Vac	24VA 50-60Hz	FUSET1A	Refer all service to qualifiedpersonnel.
WARNING:Checkfuse									user serviceable parts inside.
									No
									WARNING:
				Ch7/8
				Ch5/6
			Digital		Inputs
				Ch3/4
				Ch1/2
	Inc.								ModelDP571 DolbyE Encoder
Dolbyandthedouble-Dsymbol	trademarksofDolbyLaboratories	Dolby Laboratories Inc.		FranciscoSan and U.K.
Dolbyandthedouble-Dsymbol	trademarksofDolbyLaboratories	Dolby Laboratories Inc.		LTCInMadeinU.S.A.		XXXXXS/N
	are
				VideoRef
				MainOut
	In			PCMDelay				Out
				PCMDelay
			10BASE-T
			Metadata						Remote
			Auxiliary						Status

Figure 3-2DP571 front and back panel

3-2

Image 34

Contents

Dolby E Model DP571 Encoder Model DP572 DecoderUnited States Dolby Laboratories IncUnited Kingdom Table of Contents 10BASE-T DP572 Setup Mode Menu Reference Page List of Figures List of Tables Preface Regulatory Notices CanadaIEC Notices Important Safety Notice Aviso Importante De Seguridad Belangrijk Veiligheids-voorschriftChapter Introduction Unpacking and Inspection Unpacking and Inspection Fusing InformationCheck Main Fuse Internal Fuse 1Checking the main fuseDigital I/O Signal CharacteristicsSystem Considerations Video ReferenceConnection with the DP569 Multichannel Encoder 2Connection between a DP569 and DP572Front-Panel User Interface Conventions3DP571 and DP572 front-panel controls and LEDs Menu Selection and Push-button Operation Display LEDs Dolby E Program ConfigDisplay Output/Input DataTC and Main Fault, Remote, PCM Dly, Error, and VRefName Function Input/Output Channel ActivityRemote Quickstart Guide for the DP571 and DP572 Dolby E 20bit Channel Configuration Common Features of the DP571 and DP572PCM Delay Channel MetadataConfiguring Jumper Settings Connector Tx Term On Rx Term OnChapter Common Dolby E Applications Film Music Commercial and Interstitial News and Local Programming Live EventsPostproduction 1Typical Dolby E system in a postproduction facilityPage Chapter DP571 Dolby E Encoder Hardware Reference2DP571 front and back panel Digital Inputs PCM Delay InputLTC Input Main Out PCM Delay OutUsing the Status Port to Select Presets StatusAuxiliary Pin 7 Transition Pin 8 Transition PresetPreset Tally a Preset Tally B 11 10BASE-TDP571 Setup Mode Menu Reference 3DP571 Unit Setup menusNotational Conventions Program ConfigEncoding Considerations Program Program and Channel Explanation Config Time Code Input Operating ModeMetadata Revert 48kHz Pull Down Metadata SourceAC-3 Metadata Frame RateBit Depth Presets PresetsBitstream Mode Channel Mode Center Dwnmx Lev Enter EscEnter Metadata ParamsReversion Preset Channel ModeRF Mode Pro Dolby Srnd ModeLine Mode Pro Dialogue LevelSystem Settings DP571 Status Mode MenuFirmware Upgrade Chapter DP572 Dolby E Decoder 2DP572 front and rear panels PCM Input Main6 10BASE-T Using the Status Port to Select Voiceover and Switched Modes Pin Direction Connection ExplanationDigital Outputs PCM Delay OutputCtrl in pin PCM Chan Config Output Routing Mode LTC OutputDP572 Setup Mode Menu Reference 3DP572 Unit Setup menuPCM Bypass Program PlayKHz Pull Down Bypass MetadataBypass Latency PCM Chan ConfigOutput Routing Headphone Prog Voiceover ModeDelay SRC Voiceover AttenPCM Delay Headphone MapDP572 Status Mode Menu DP572 Unit Setup Firmware UpgradePage Chapter System Specifications