Dolby E Multichannel Distribution System User Manual | DP572 Dolby E Decoder |
|
|
|
|
The state of the pins is normally high (internal pull up), and they detect a
Table
Ctrl in pin 8 | Ctrl in pin 7 | PCM Chan Config | |
Output Routing Mode | |||
|
| ||
|
|
| |
High | High | External Standby | |
|
|
| |
High | Low | Voiceover | |
|
|
| |
Low | High | Switched Out | |
|
|
| |
Low | Low | Reserved | |
|
|
|
4.1.9Digital Outputs
A maximum of eight channels of decoded audio are supplied on the four AES3 outputs. A second electrically isolated output is supplied for each channel pair.
Note: The digital outputs are electrically separate, not passive
4.1.10PCM Delay Output
Encoding delay is added to the PCM signal which is then transmitted from the PCM Delay Out connector. The DSP subsystem calculates the delay equivalent to the main channel latency and applies it to the PCM Delay Out. If PCM bypass mode is enabled, the delay matches that of the bypass channel.
4.1.11LTC Output
After