Electrolux ERN 23500, ERN 16300 manual Something not Working, Customer service and spare parts

SYMPTOM

SOLUTION

Door does not close

Level properly the appliances if it is not well levelled.

Weight surpasses the storage limit of the door shelf so spread weight more evenly or

take some products out.

The appliance is not properly installed. Please look in the ÒBuilding-inÓ section.

It is too warm inside the refrigerator

Set a lower temperature.

Distribute the food products to allow cold air to circulate around them.

Make sure that the door is completely closed and that the insulating strip is complete

and clean.

The temperature where the cabinet is placed is above normal room temperature.

It is too cold inside the refrigerator.

Turn the temperature regulator to a warmer setting temporarily.

The compressor works continuously.

Turn the thermostat knob to a lower number.

The temperature where the cabinet is placed is above normal room temperature.

Check that the ventilation is sufficient and that the ventilation openings are

unobstructed.

The cause could be the introduction of large quantities of food and/or frequent

opening/closing of the door.

There is water inside/outside the refrigerator.

Sometimes is normal. During automatic defrosting frost thaws on the cooling plate.

Water comes out on the floor.

Place the drain hose at the back of the cabinet above the drain bowl.

Noises

Sometimes this is normal. Temperature control may cause clicking sounds when the

system is connected or disconnected.

The injected cooling gas may produce a gurgling sound while passing through the

tubes.

The motor may cause a humming noise and/or slight bumping.

The insulation material used has a tendency to slighly increase noise levels, how ever it

allows for much better insulation and a lower energy consumption.