8electrolux
Problem
Possible cause
Solution
The compressor does not start immediately af- ter pressing the Action Coolswitch, or after changing the tempera- ture.
Water flows on the rear plate of the refrigerator.
Water flows into the re- frigerator.
Temperature cannot be set .
The temperature in the appliance is too low/high.
The temperature in the re- frigerator is too high.
The door has been opened too frequently.
The product temperature is too high.
The room temperature is too high.
This is normal, no error has oc- curred.
During the automatic defrosting process, frost defrosts on the rear plate.
The water outlet is clogged.
Products prevent that water flows into the water collector.
Action Cool function switched on.
The temperature regulator is not set correctly.
The door is not closed correctly.
The product temperature is too high.
Many products are stored at the same time.
There is no cold air circulation in the appliance.
Do not keep the door open longer than necessary.
Let the product temperature de- crease to room temperature be- fore storage.
Decrease the room temperature.
The compressor starts after a pe- riod of time.
This is correct.
Clean the water outlet.
Make sure that products do not touch the rear plate.
Switch off Action Cool manually, or wait to set the temperature un- til the function has reset automati- cally. Refer to "Action Cool func- tion".
Set a higher/lower temperature.
Refer to "Closing the door".
Let the product temperature de- crease to room temperature be- fore storage.
Store less products at the same time.
Make sure that there is cold air cir- culation in the appliance.
Replacing the lamp
1.Disconnect the mains plug from the mains socket.
2.Press on the rear hook and at the same time slide the lamp cover in the direction of the arrow.
3.Replace the lamp with one of the same power and specifically designed for household appliances. (the maximum power is shown on the light lamp cover)
4.Install the lamp cover by sliding it into its original position.
5.Connect the mains plug to the mains socket.
6.Open the door. Make sure that the lamp comes on.