Electrolux IK224010 user manual Technical Data, Installation, Closing the door, Positioning

Page 9

electrolux 9

Closing the door

1. Clean the door gaskets.

2. If necessary, adjust the door. Refer to "In- stallation".

3. If necessary, replace the defective door gaskets. Contact the Service Center.

TECHNICAL DATA

Dimension of the recess

Height

Width

Depth

The technical information are situated in the rating plate on the internal left side of the ap- pliance and in the energy label.

1225 mm

560mm

550mm

INSTALLATION

Read the "Safety Information" carefully for your safety and correct operation of the appliance before installing the appliance.

Positioning

Install this appliance at a location where the ambient temperature corresponds to the cli- mate class indicated on the rating plate of the appliance:

To remove them proceed as follows:

1.Move the shelf holders in the direction of the arrow (A).

2.Raise the shelf from the rear and push it forward until it is freed (B).

3.Remove the retainers (C).

Climate

class

SN

N

ST

T

Ambient temperature

+10°C to + 32°C +16°C to + 32°C +16°C to + 38°C +16°C to + 43°C

Removing the shelf holders

Your appliance is equipped with shelf retain- ers that make it possible to secure the shelves during transportation.

Image 9
Contents Fridge Safety Information ContentsInstallation Care and cleaningService Daily useControl Panel Daily USE First USEHelpful Hints and Tips Care and CleaningWhat to do IF… Periods of non-operationDisconnect the appliance from elec- tricity supply Replacing the lamp Problem Possible cause SolutionInstallation Technical DataClosing the door PositioningElectrical connection Environmental ConcernsVentilation requirements Airflow behind the appliance must be sufficientElectrolux 212700221-00-17052010