![](/images/new-backgrounds/1042594/4259431x1.webp)
16 | Control buttons |
|
Control buttons
This hood is equipped with an electronic motor and lamp control.
The control is able to set 4 different fan speeds, turn ON/OFF light and has a timer function.
In the following drawing are described the main key functions.
1 | 2 | 3 | 4 | 5 | ||||
|
|
|
|
|
|
|
|
|
1.Light Button
•Press lamp button to turn ON the light (Lamp state previously OFF).
•Press lamp button to turn OFF the light (Lamp state previously ON).
2.Timer Button
•The default timer setting is 10 minutes, and it can be adjusted between 20 minutes and 1minute.
•After pressing the timer button, the control enters to a timer setup mode, and user can
adjust the timer countdown time with the
“” and “
” buttons within 5 seconds. The timer can be initiated immediately
pressing the timer button, after setting the timer duration or pressing the timer button twice (default 10 minutes setting).
•If no action occurs within 5 seconds, the countdown will start.
•During the timer setup the “” and “
” buttons are dedicated to the timer and no
motor action will occur.
•Once the timer is initiated, it can be cancelled by pressing the timer button again.
3.Display
•Shows the hood settings.
4.“
” Button. Speed Decrease / OFF
•This button is used to decrease the fan speed, or turn OFF the fan.
•The fan will turn OFF if the “” button is pressed and the hood was in the first speed.
•If the fan is at second speed and the “” button is pressed, the fan will be set to first
speed.
•If the fan is at third speed and the “” key is pressed, the fan will be set to second speed.
•If the fan is at fourth speed and the “” button is pressed, the fan will be set to third
speed.
•If the fan is OFF and the “” button is pressed, the control backlight will light up.
5.“
” Button. Speed Increase / ON
•This button is used to increase the fan speed, or turn ON the fan.
•The fan will turn ON if the “” button is pressed and the hood was OFF.
•If the fan is at first speed and the “” button is pressed, the fan will be set to second
speed.
•If the fan is at second speed and the “” button is pressed, the fan will be set to third
speed.
•If the fan is at third speed and the “” button is pressed, the fan will be set to fourth
speed.
•If the fan is at fourth speed and the “” button is pressed, a beep will sound.
IMPORTANT: If the hood doesn’t switch ON, before calling for service, check if the internal General ON/ OFF
General ON/OFF
Push button Switch
Frontside of the hood
Back side of the hood