Electrolux EI36WC60GS, EI30WC60GS Mounting the duct cover bracket, Ceiling ducting, Wall ducting

Mounting the duct cover bracket

The duct bracket should be installed against the back wall and flush with the ceiling. This bracket will hold the telescopic duct cover in place at the top (this a extra accessory available not included with the hood).

.

Secure the bracket to the wall:

•Align the marked centerline on the bracket with the centerline on the wall.

•Mark 2 screw hole locations in the wall.

•Drill 5/16" pilot holes in the marked locations.

•Install wall fastener anchors.

•Drive wood screws, by hand, into the fastener to allow anchors to expand. Remove the screws.

•Secure the bracket to the wall with wood screws and/or fasteners.

Ceiling ducting

If the duct will vent straight up to the ceiling:

•Use level to draw a line straight up, from the centerline on the template to the ceiling.

•Measure at least 4 -12/16 ” from the back wall to the circle center of an 8-½” hole on the ceiling.

Wall ducting

If ductwork will vent to rear:

•Use a level to draw a line straight up from the centerline on the template.

•Measure at least 23 - 12/16" (the measure might vary depending on the elbow used) above the pencil line that indicates the bottom installation height, to the circle center of an 8-½” diameter duct hole (Hole may be elongated for duct elbow).

House wiring location

•The junction box is located on the top left side of the hood.

•Wiring should enter the back wall at least 20" above the bottom of the installation height, and within 5-7/8" and 4-7/8"of the left side of the centerline.

Wall

Vertical centerline

4-3/4" circle center to wall

8-1/2" dia. hole

FOR

WALL

VENT

DUCT

FOR CEILING VENT DUCTING

Ceiling

Circle center at 23 3/4" above the marked bottom

pencil line.