Electrolux QB 5201 Unloading the dishwasher, Care and cleaning, End of the washing programme

Page 20

20Unloading the dishwasher

Interrupt a washing programme in progress

•Open the dishwasher door; the programme will stop. Close the door; the programme will start from the point at which it was interrupted.

•Press the On/Off button, all lights will turn off. Press the On/Off button again; the pro- gramme will start from the point at which it was interrupted.

End of the washing programme

•The dishwasher will automatically stop and an audible signal informs you of the end of the washing programme.

•The light of the programme just ended will remain on.

•In the digital display appears a zero.

1. Switch off the dishwasher by pressing the On/Off button.

It is recommended to switch off the appliance once the washing programme has ended. If this is not done, automatically after about 3 minutes from the end of the programme, all indicator lights will go off. The digital display shows 1 horizontal bar.

This will help to reduce the consumption of energy when you forget or for any reason cannot switch the appliance off once the programme has ended.

Press any button (except On/Off) and the control panel will show the same situation (in- dicator lights and digital display) as when the programme ended.

2.Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes; in this way they will be cooler and the drying will be improved.

Unloading the dishwasher

•Hot dishes are sensitive to knocks.

The dishes should therefore be allowed to cool down before removing from the appliance.

•Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one.

•Water may appear on the sides and the door of the dishwasher as the stainless steel will eventually become cooler than the dishes.

CAUTION!

When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off.

Care and cleaning

Cleaning the filters

The filters must be checked and cleaned from time to time. Dirty filters will degrade the washing result.

WARNING!

Before cleaning the filters ensure that the machine is switched off.

1. Open the door, remove the lower basket.

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Dishwasher Contents Safety information General safetyChild safety Safety informationInstallation Product descriptionControl panel A1 2002 + A2Setting mode Digital displayExtra Silent button Function buttonsSetting the water softener First useExamples Setting manuallySetting electronically Use of dishwasher salt Use of rinse aidTo fill Salt for the first timeAdjusting the dosage of rinse aid Daily use Loading cutlery and dishesDaily use Open the door and slide out the baskets to load the dishesLoading cutlery and dishes Lower basketCutlery basket Ket Upper basketPlace the grid insert on the cutlery basket Adjusting the height of the upper basket Raising / lowering the upper basket Use of detergentFill with detergent Multitab function Detergent tabletsAdjust the rinse aid dosage Washing programmesActivation/deactivation of the Multitab function Activation/deactivation of the rinse aid dispenserWashing programmes Energy kWh Water litresSelect and start a washing programme Setting and starting the programme with delay startCancelling a delay start or a washing programme in progress Care and cleaning Cleaning the filtersUnloading the dishwasher Interrupt a washing programme in progressNever try to remove the spray arms Cleaning the spray armsCare and cleaning What to do if… Appears in the digital display Technical data Technical dataInstallation Building-in Installation Adjusting the height of the plinth Water connection Water supply connectionsWater outlet hose connection Locknut must be correctly fitted to avoid water leaksElectrical connection Drain hose spigotEnvironment concerns Packaging materialPage Page 117956650-122008
Top Page Image Contents