Installation 25
Remove all packaging before positioning the machine.
If possible, position the machine next to a water tap and a drain.
Building-in
This dishwasher is designed to be fitted under a kitchen counter or work surface. It is essential that the recess dimensions indica-
ted in the illustration are followed.
The height of the recess where the dishwasher is to be installed can vary between 820 and 880
mm from the floor since the dishwasher is fitted with adjustable feet (max. 60 mm). No further openings for the venting of the dish- washer are required, but only to let the water fill and drain hose and power supply cable pass through. Leave a space of 2 mm between the top of the
dishwasher and the underside of the kitchen counter. During all operations that involve accessibility to
internal components the dishwasher has to be unplugged.
When inserting the machine, ensure that the water inlet hose, the drain hose and the supply cable are not kinked or squashed.
Adjusting the height of the dishwasher
To adjust the height proceed as follows:
1.Loosen or tighten the two front feet.
2.Loosen and remove the adjustable plinth.
3.Adjust the rear foot by turning the screw in the middle of the front kick plate to the left or to the right. Good levelling is essential for correct closure and sealing of the door.
When the appliance is correctly levelled, the door will not catch on the levelling spacers on either side of the cabinet. If the door does not close properly, loosen or tighten the ad- justable feet until the machine is perfectly level.