Electrolux QB 5201 user manual Electrical connection, Drain hose spigot

Page 28

28Electrical connection

The waste connection must be at a height of be-

tween 30 cm (minimum) and 100 cm (maximum) from the bottom of the dishwasher. The drain hose can face either to the right or left

of the dishwasher. Ensure the hose is not bent or squashed as this could prevent or slow down the discharge of wa-

ter.

The sink plug must not be in place when the ma- chine is draining as this could cause the water to

syphon back into the machine.

If you use a drain hose extension it must be no longer than 2 metres and its internal diameter must be no smaller than the diameter of the hose provided.

Likewise the internal diameter of the couplings used for connections to the waste outlet must be no smaller than the diameter of the hose provided.

When connecting the drain hose to an under sink

trap spigot, the entire plastic membrane (A) must be removed . Failure to remove all the membrane will result in food particles building up over time eventually blocking the dishwasher

drain hose spigot.

Our appliances are supplied with a security device to protect against the return of dirty water back into the machine. If the spigot of your sink has a "no return valve" incorporated this can prevent

the correct draining of your dishwasher. We therefore advise you to remove it.

To avoid water leakage after installation make sure that the water couplings are tight.

Electrical connection

WARNING!

Safety standards require the appliance to be earthed.

Prior to using the appliance for the first time, ensure that the rated voltage and type of supply on the rating plate match that of the supply where the appliance is to be installed. The fuse rating is also to be found on the rating plate.

Always plug the mains plug into a correctly installed shockproof socket. Multi-way plugs, connectors and extension cables must not be used.

This could constitute a fire hazard through overheating.

If necessary, have the domestic wiring system socket replaced. In case that the electrical cable has to be replaced, contact your local Service Force centre.

The plug must be accessible after the appliance has been installed. Never unplug the appliance by pulling on the cable. Always pull the plug.

The manufacturer accepts no liability for failure to observe the above safety precautions.

Image 28
Contents Dishwasher Contents Safety information General safetyChild safety Safety informationInstallation Product descriptionControl panel A1 2002 + A2Setting mode Digital displayExtra Silent button Function buttonsSetting the water softener First useSetting electronically Setting manuallyExamples Use of dishwasher salt Use of rinse aidTo fill Salt for the first timeAdjusting the dosage of rinse aid Daily use Loading cutlery and dishesDaily use Open the door and slide out the baskets to load the dishesCutlery basket Lower basketLoading cutlery and dishes Place the grid insert on the cutlery basket Upper basketKet Adjusting the height of the upper basket Fill with detergent Use of detergentRaising / lowering the upper basket Multitab function Detergent tabletsAdjust the rinse aid dosage Washing programmesActivation/deactivation of the Multitab function Activation/deactivation of the rinse aid dispenserWashing programmes Energy kWh Water litresCancelling a delay start or a washing programme in progress Setting and starting the programme with delay startSelect and start a washing programme Care and cleaning Cleaning the filtersUnloading the dishwasher Interrupt a washing programme in progressCare and cleaning Cleaning the spray armsNever try to remove the spray arms What to do if… Appears in the digital display Installation Technical dataTechnical data Building-in Installation Adjusting the height of the plinth Water connection Water supply connectionsWater outlet hose connection Locknut must be correctly fitted to avoid water leaksElectrical connection Drain hose spigotEnvironment concerns Packaging materialPage Page 117956650-122008