Electrolux FAVORIT 60870 manual Start the Wash Programme, Changing/Interrupting/Cancelling

Page 28

Operating Instructions

Start the Wash Programme

0 1. Check that when the dishes and cutlery are loaded into the dishwasher the spray arms are free to rotate.

2.Open the tap fully.

3.Shut the door.

4.Press the ON/OFF button. The ON/OFF button indicator illuminates.

5.Press the programme button for the desired programme (see "Pro- gramme Table"). The programme indicator illuminates. The selected programme begins after around 6 seconds. The time remaining until the end of the programme is displayed on the multi-display, the time calculated is dependent on the load in the baskets.

With automatic programme adjustment this residual time count can be stopped or corrected if necessary (load quantity, degree of dirtiness, etc.) using the dishwasher control.

3

If fault messages are displayed on the multi-display after the start of

 

the programme, please read the "What to do, if..." section.

 

Changing/Interrupting/Cancelling

 

the Wash Programme

3

Only change or interrupt a wash programme in progress if it is abso-

 

lutely necessary to do so.

 

Changing the wash programme

3

If you want to change the wash programme within 6 seconds of mak-

 

ing a programme selection, briefly press the button for the new wash

 

programme.

 

If you want to change the wash programme at a later point in time, use

 

the following procedure:

0 1. Press the button for the new wash programme and hold it pressed. The indicators for both programmes now flash.

2.After a few seconds only the indicator for the new programme flashes. Release the programme button, the new programme is now running.

28

Page 27 Page 29
Image 28
Page 27 Page 29
Contents
Favorit Tips on using the appliance Dear customerPlease read these user instructions carefully Pass them on to any subsequent owner of the applianceContents Installation and Connection Instructions What to do, ifSafety Instructions Installation, Connection and Placing into OperationChild Safety General SafetyCorrect Use Disposal Economical and Ecological DishwashingDisposing of the Packaging Material Disposal of Old AppliancesAppliance Features and Control Panel Control Panel Multi-Display can displayPrior to using for the first time Special salt Adjusting the Water SoftenerYour area Electronic adjustment Filling with Salt for the Water Softener Fill with dishwasher saltUse dishwasher salt Open the door, remove the lower Basket Turning it anticlockwiseRinse Aid Switching Rinse Aid Supply On and OffThere are two ways to add rinse aid Filling with Rinse Aid Fully open the rinse aid compartment lidAdjusting Rinse Aid Dosing Daily UseLoading Cutlery and Dishes Not be washed in the dishwasherLoading Cutlery Tioned horizontally in the upper basketPlace knives, small spoons and small Forks in the cutlery trayOpen the two part handle Or work surfaceRemove cutlery Close the two part handle Loading Pans, Frying Pans Large Plates Load large and heavily soiled dishes in the lower basketFolded over to the left To ease the loading of large itemsFolded across one another Across one anotherTwo rear plate inserts in the lower Baskets can be folded across one anotherLoading Cups, Glasses and Coffee Services Lowering the Upper Basket Adjusting the Height of the Upper BasketRaising the Upper Basket Filling with Detergent Fill with detergentSpecial Advice General AdviceUse of 3 in 1/ Combi Detergent Tablets Detergent tablets Concentrated DetergentAutomatic Wash Programmes Selecting the Wash Programme Programme Table SoilingChanging/Interrupting/Cancelling Start the Wash ProgrammeWash Programme Changing the wash programmeSetting or Changing the Delay Start Timer Care and Cleaning Switching Off the DishwasherLoad Sensing Sensor Logic Emptying the DishwasherCleaning the Filter StancesError messages What to do, ifThere are problems with the operation of the dish- washer Washer useWash results are not satisfactory Dishes are still dirtyDishes are wet and dull There are dried water drops on the glasses and dishesTechnical Data Upper basket without cutlery tray Sample loading arrangementsLower basket with cutlery basket Installing the Dishwasher See enclosed installation instructionsBuilt-Under Dishwasher Free-Standing AppliancesPlinth on free-standing appliances is not adjustable Work surface must be re-mountedConnecting the Dishwasher Water ConnectionPermitted water pressure Connect the inlet hoseWater inlet hose with safety valve Please take care when installing the water inlet hoseWater drain Leak Prevention System Appliance is automatically pumped outElectrical Connection Changing a fuseConnections Guarantee Conditions Page Customer Care 08705 929Calls may be recorded for training purposes AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG
Top Page Image Contents