Electrolux FAVORIT 50730 Filling with Salt for the Water Softener, Fill with dishwasher salt

Page 12

Operating Instructions

Filling with Salt for the Water Softener

1

Use only salt designed for dishwashers. Never fill the salt container

 

with any another type of salt (e.g. culinary salt) or dishwasher deter-

gent as this would irreparably damage the water softener.

Prior to filling with salt, please check each time that you really do have a packet of dishwasher salt in your hand.

Fill with dishwasher salt:

Prior to using the dishwasher for the first time

When the SALT indicator J on the control panel is illuminated.

3

If the water hardness in your area is less than 4 °d, you do not need to

 

use dishwasher salt. The SALT indicator J on the control panel will

 

remain illuminated.

 

 

0 1.

Open the door, remove the lower

 

 

 

 

 

 

 

rack.

SALE

 

 

 

 

 

 

 

 

 

 

 

 

 

2.

Undo the lid on the salt container by

SALT

 

 

 

 

SALZ

 

 

 

 

 

turning it anticlockwise.

SEL

 

 

 

 

3.When using for the first time: fill the salt container with water.

4.Place the funnel supplied on the con-

tainer opening.

Fill the container with salt through

the funnel; the capacity of the con- tainer is approx. 1.0-1.5 kg depend- ing on the grain size. Do not overfill

the salt container with salt.

3

The water expelled by filling the salt container with salt runs out of the

 

salt container onto the base of the washing compartment. This is not a

cause for concern, the water will be pumped out at the start of the next wash programme.

5.Clean any salt remnants on the container opening.

6.Turn the lid clockwise to the stop, otherwise dishwasher salt will leak into the wash water, this could lead to poor wash results. To avoid this run a rinse programme after filling the salt container with special salt. This will wash away salt water and any salt crystals that have been spilt.

3

Depending on the size of the salt grains, it can take several hours for

 

the salt to dissolve in the water and the special salt indicator J to

extinguish. The setting of the water softener and the consumption of salt are dependent on the hardness of the local water.

12

Image 12
Contents Favorit Tips on using the appliance Dear customerPlease read these user instructions carefully Pass them on to any subsequent owner of the applianceContents Installation and Connection Instructions Safety Instructions Installation, Connection and Placing into OperationChild Safety General SafetyCorrect Use Disposal Economical and Ecological DishwashingDisposing of the Packaging Material Disposal of Old AppliancesAppliance Features and Control Panel Which fault has occurred on the dishwasher Control panelNing Prior to using for the first time Adjust the water softenerYour area PanelDishwasher must be switched off Manual settingElectronic setting Ing the appropriate buttonFilling with Salt for the Water Softener Fill with dishwasher saltRemain illuminated Open the door, remove the lower Rack Turning it anticlockwiseTo switch off the control indicator for rinse aid Rinse aidRinse aid can be added in one of two ways Filling with rinse aid Fully open the rinse aid compartment lidAdjusting Rinse Aid Dosing Daily Use Loading Cutlery and DishesNot be washed in the dishwasher Loading Cutlery Loading Pans, Frying Pans Large Plates Load large and heavily soiled dishes in the lower rackOver to the left To ease the loading of large itemsFolded across one another Across one anotherTo ease the loading of large items Two rear plate inserts in the lowerLoading Cups, Glasses and Coffee Services Adjusting the Height of the Upper Basket Lowering the Upper BasketRaising the Upper Basket Filling with Detergent Fill with detergentGeneral Advice Special AdviceUse of 3 in 1/ Combi Detergent Tablets Concentrated Detergent Detergent tabletsSelecting the Wash Programme Programme Table SoilingStart the wash programme Interrupting or ending the wash programmeWasher Open the door carefullySetting or changing the delay start timer Setting the delay start timerChanging the delay start timer Pause functionCare and Cleaning Switching Off the DishwasherLoad Sensing Sensor Logic Emptying the DishwasherCleaning the Filter Fault warnings are displayed What to do, ifThere are problems operating the dishwasher Wash results are unsatisfactoryDishes are still dirty Dishes are wet and dullTechnical Data Decrease rinse aid dosingThere are dried water drops on the glasses and dishes Sample loading arrangements Upper basket Lower basket with cutlery basketInstalling the Dishwasher See enclosed installation instructionsBuilt-Under Dishwasher Free-Standing AppliancesPlinth on free-standing appliances is not adjustable Work surface must be re-mountedConnecting the Dishwasher Water ConnectionPermitted water pressure Connect the inlet hoseWater inlet hose with safety valve Please take care when installing the water inlet hoseWater drain Leak Prevention System Appliance is automatically pumped outOff Electrical Connection Changing a fuseConnections Guarantee Conditions 08705 929 Customer CareCalls may be recorded for training purposes AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG