Electrolux FAVORIT 50730 manual Work surface must be re-mounted

Page 35

Installation and Connection Instructions

If the dishwasher is installed underneath a kitchen work surface, the original work surface of the dishwasher is to be removed as follows:

0 1. Unscrew the screws from the posi- tioning plates on the back (1).

2.Slide the appliance's work surface

approx. 1 cm to the rear (2).

3. Lift the work surface at the front (3) and remove.

1	If the dishwasher is later used as a free-standing appliance, the original
	work surface must be re-mounted.
3	The plinth on free-standing appliances is not adjustable.

Image 35

Contents Favorit Pass them on to any subsequent owner of the appliance Tips on using the applianceDear customer Please read these user instructions carefullyContents Installation and Connection Instructions General Safety Safety InstructionsInstallation, Connection and Placing into Operation Child SafetyCorrect Use Disposal of Old Appliances DisposalEconomical and Ecological Dishwashing Disposing of the Packaging MaterialAppliance Features and Control Panel Ning Which fault has occurred on the dishwasherControl panel Panel Prior to using for the first timeAdjust the water softener Your areaIng the appropriate button Dishwasher must be switched offManual setting Electronic settingTurning it anticlockwise Filling with Salt for the Water SoftenerFill with dishwasher salt Remain illuminated Open the door, remove the lower RackRinse aid can be added in one of two ways To switch off the control indicator for rinse aidRinse aid Fully open the rinse aid compartment lid Filling with rinse aidAdjusting Rinse Aid Dosing Not be washed in the dishwasher Daily UseLoading Cutlery and Dishes Loading Cutlery To ease the loading of large items Loading Pans, Frying Pans Large PlatesLoad large and heavily soiled dishes in the lower rack Over to the leftTwo rear plate inserts in the lower Folded across one anotherAcross one another To ease the loading of large itemsLoading Cups, Glasses and Coffee Services Raising the Upper Basket Adjusting the Height of the Upper BasketLowering the Upper Basket Fill with detergent Filling with DetergentUse of 3 in 1/ Combi Detergent Tablets General AdviceSpecial Advice Detergent tablets Concentrated DetergentSoiling Selecting the Wash Programme Programme TableOpen the door carefully Start the wash programmeInterrupting or ending the wash programme WasherPause function Setting or changing the delay start timerSetting the delay start timer Changing the delay start timerEmptying the Dishwasher Care and CleaningSwitching Off the Dishwasher Load Sensing Sensor LogicCleaning the Filter What to do, if Fault warnings are displayedDishes are wet and dull There are problems operating the dishwasherWash results are unsatisfactory Dishes are still dirtyThere are dried water drops on the glasses and dishes Technical DataDecrease rinse aid dosing Upper basket Lower basket with cutlery basket Sample loading arrangementsFree-Standing Appliances Installing the DishwasherSee enclosed installation instructions Built-Under DishwasherWork surface must be re-mounted Plinth on free-standing appliances is not adjustableConnect the inlet hose Connecting the DishwasherWater Connection Permitted water pressurePlease take care when installing the water inlet hose Water inlet hose with safety valveWater drain Off Leak Prevention SystemAppliance is automatically pumped out Changing a fuse Electrical ConnectionConnections Guarantee Conditions Calls may be recorded for training purposes 08705 929Customer Care AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG

work surface must be re-mounted.

The plinth on free-standing appliances is not adjustable.