Electrolux FAVORIT 50730 manual Water inlet hose with safety valve

Page 37

	Installation and Connection Instructions
3	The following section is only applicable to dishwashers that have a
	safety valve on the threaded hose fitting for the tap:
	Water inlet hose with safety valve
	After connecting the double-walled water inlet hose, the safety valve is
	next to the tap. Therefore the water inlet hose is only under pressure
	while the water is running. If the water inlet hose starts to leak during
	this operation, the safety valve cuts off the running water and the
	draining pump in the dishwasher is switched on.
1	Please take care when installing the water inlet hose:
	– The distance between the bottom
	edge of the safety value and the
	floor on which the dishwasher is
	standing must be at least 30 cm:
	– The electrical cable for the safety
	valve is in the double-walled water
	inlet hose. Do not immerse the
	water inlet hose or the safety valve
	in water.
	– If the water inlet hose or the safety
	valve is damaged, remove the
	mains plug immediately.
	– A water inlet hose with safety valve
	must only be replaced by your local
	Service Force Centre.
	– Place the water inlet hose in such a way that it is never higher than
	the bottom edge of the safety valve.

37

Image 37

Contents Favorit Dear customer Tips on using the appliancePlease read these user instructions carefully Pass them on to any subsequent owner of the applianceContents Installation and Connection Instructions Installation, Connection and Placing into Operation Safety InstructionsChild Safety General SafetyCorrect Use Economical and Ecological Dishwashing DisposalDisposing of the Packaging Material Disposal of Old AppliancesAppliance Features and Control Panel Control panel Which fault has occurred on the dishwasherNing Adjust the water softener Prior to using for the first timeYour area PanelManual setting Dishwasher must be switched offElectronic setting Ing the appropriate buttonFill with dishwasher salt Filling with Salt for the Water SoftenerRemain illuminated Open the door, remove the lower Rack Turning it anticlockwiseRinse aid To switch off the control indicator for rinse aidRinse aid can be added in one of two ways Fully open the rinse aid compartment lid Filling with rinse aidAdjusting Rinse Aid Dosing Loading Cutlery and Dishes Daily UseNot be washed in the dishwasher Loading Cutlery Load large and heavily soiled dishes in the lower rack Loading Pans, Frying Pans Large PlatesOver to the left To ease the loading of large itemsAcross one another Folded across one anotherTo ease the loading of large items Two rear plate inserts in the lowerLoading Cups, Glasses and Coffee Services Lowering the Upper Basket Adjusting the Height of the Upper BasketRaising the Upper Basket Fill with detergent Filling with DetergentSpecial Advice General AdviceUse of 3 in 1/ Combi Detergent Tablets Detergent tablets Concentrated DetergentSoiling Selecting the Wash Programme Programme TableInterrupting or ending the wash programme Start the wash programmeWasher Open the door carefullySetting the delay start timer Setting or changing the delay start timerChanging the delay start timer Pause functionSwitching Off the Dishwasher Care and CleaningLoad Sensing Sensor Logic Emptying the DishwasherCleaning the Filter What to do, if Fault warnings are displayedWash results are unsatisfactory There are problems operating the dishwasherDishes are still dirty Dishes are wet and dullDecrease rinse aid dosing Technical DataThere are dried water drops on the glasses and dishes Upper basket Lower basket with cutlery basket Sample loading arrangementsSee enclosed installation instructions Installing the DishwasherBuilt-Under Dishwasher Free-Standing AppliancesWork surface must be re-mounted Plinth on free-standing appliances is not adjustableWater Connection Connecting the DishwasherPermitted water pressure Connect the inlet hosePlease take care when installing the water inlet hose Water inlet hose with safety valveWater drain Appliance is automatically pumped out Leak Prevention SystemOff Changing a fuse Electrical ConnectionConnections Guarantee Conditions Customer Care 08705 929Calls may be recorded for training purposes AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG