Electrolux ESI 6220 manual Connecting the Dishwasher, Water Connection, Permitted water pressure

Page 29

Connecting the Dishwasher

Water Connection

The dishwasher is fitted with safety devices that pre- vent the wash water returning into the drinking water system and comply with the applicable plumbing reg- ulations.

•The dishwasher can be connected to cold and hot water supplies up to max. 60 °C.

•The dishwasher must not be connected to open hot water appliances or instantaneous water heat- ers.

Permitted water pressure

	Lowest permitted water pressure:	Consult your installer if the water pressure is less than 1 bar.
	1 bar (=10 N/cm2 =100 kPa)
	1 bar (=10 N/cm2 =100 kPa)
	Highest permitted water pressure:	In the case of a water pressure greater than 10 bar, a pressure reduc-
	10 bar (=100 N/cm2 =1 MPa)	tion valve must be used (available from your dealer).

Connect the inlet hose

1The water inlet hose must not be kinked, crushed or entangled when it is being con- nected up.

Connect the threaded hose fitting

(ISO 228-1:2000) on the water inlet hose to a tap with an external thread (¾ inch). Tighten the threaded hose fitting hand tight only.

3In order that access to the tap in the kitchen is not limited by the use of the dishwasher, we recommend the installation of an addi- tional tap, or fitting a two way adapter to the existing tap.

•If you need a longer water inlet hose than that supplied, VDE approved complete hose sets are to be used. These are available from your local Service Force Centre.

29

Image 29

Contents User Instructions Dear customer Contents Contents Installation, Connection and Plac- ing into Operation Safety InstructionsChild Safety General SafetyEconomical and Ecological Dishwash- ing DisposalDisposing of the Packaging Material Disposal of old appliancesAppliance Features and Control Panel Multidisplay Prior to using for the first timeControl Panel Electronic setting Adjusting the Water SoftenerManual setting Page Fill with special salt Filling with Special Salt for the Water SoftenerFill with rinse aid Adjusting Rinse Aid DosingFilling with Rinse Aid Loading cutlery and dishes Daily UseLoading Cutlery Loading Pans, Frying Pans and Large Plates Adjusting the Height of the Upper Basket Loading Cups, Glasses and Coffee ServicesLowering the Upper Basket Raising the Upper BasketFill with detergent Filling with DetergentSpecial Advice General AdviceUse of 3 in 1/ Combi Detergent Tablets Concentrated DetergentSelecting the Wash Programme Programme Table Start the wash programme Switching Off the Dish- washerInterrupting or ending the wash programme Pause functionCleaning the Filter Care and CleaningWhat to do if Fault warnings are displayedSymptom Possible Cause Solution Wash results are unsatisfactory There are problems operating the dishwasherDishes are still dirty Dishes are wet and dullDishwasher Free-Standing Appliances Technical DataDishwashers that Can Be Integrated, Built-In Dishwashers Dishwashers that Can Be Fully IntegratedFull Load Half Load Page Dishwashers That Can Be Inte- grated Installing the DishwasherFree-Standing Appliances Built-In DishwasherWater Connection Connecting the DishwasherPermitted water pressure Connect the inlet hosePlease take care when installing the water inlet hose Water inlet hose with safety valveLeak Prevention System Water drainElectrical Connection By the earth symbol Or coloured green and yel LowChanging a fuse Green and Yellow Earth Blue Neutral Brown LiveConnections Standard guarantee conditions Guarantee ConditionsEuropean Guarantee This guarantee does not coverCustomer Care 08705 929Electrolux plc