Start the wash programme
1.Check that when the dishes and cutlery are loaded in the dishwasher the spray arms are free to rotate.
2.Open the tap fully.
3.Shut the door.
4.Press the On/Off button. The On/Off button indica- tor lights up.
5.Press the programme button for the required pro- gramme (see “Programme Table”). The pro- gramme indicator lights up. One or two lights will flash in the multidisplay. During this time it is pos- sible to reselect the programme. The selected wash programme will start after about 6 seconds. The current wash programme stage will always be shown in the multidisplay.
3If the top light and/or the middle light in the multidisplay flash after the programme has started please read the section “What to do if...”.
Interrupting or ending the wash programme
3Only interrupt a wash programme that is run- ning if it is absolutely necessary. After the appliance has been closed again the air that has entered will be greatly heated and expand. As a result water may penetrate the base of the appliance and trigger the anti- flood system.
Interrupt the wash programme by open- ing the door.
1Hot steam can escape from the appliance when the door is opened. (deleted by the reviewer) Open the door carefully.
1.Open the door of the dishwasher. The wash pro- gramme will stop.
2.Lights are flashing in the multidisplay.
3.Shut the door. The wash programme continues.
Ending the wash programme
1.Press the button for the wash programme that is running and hold it down until the programme indi- cator for the wash programme goes out.
2.Release the programme button; the wash pro- gramme has been ended.
Pause function
3The pause function can only be initiated before the drying section of the programme. If the pause function is initiated during the drying section of the programme the wash programme is ended.
Using the pause function the dishwasher can be tem- porarily stopped.
1.Press the On/Off button. The wash programme will stop.
2.All indicators will go out.
3.When after a short time the wash programme is to continue, press the On/Off button again. The wash programme will continue.
2The wash programme should not be stopped for a prolonged period or the cooled water will need to be reheated resulting in increased energy consumption.
Load Sensing
If a wash programme is started even though there are only a few dishes in the upper and/or lower basket, an intelligent electronic system adjusts the amount of water and the duration of the wash programme to the number of dishes. By this means it is possible to wash only a few dishes quickly and economically. At half load (6 place settings), up to 2 litres of water and 0.2 kWh of electricity are saved.
Switching Off the Dish- washer
Switch off the dishwasher when wis illuminated on the programme progress display.
1.Press the ON/OFF button M. The ON/OFF but- ton Mindicator extinguishes.
1Hot steam may escape from the appliance when opening the door immediately after the end of the programme. Therefore:
2.Open the door carefully.
Emptying the Dishwasher
3
•Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down before removing them from the appliance.
•Leave the dishes in the dishwasher for approx. 15 minutes after the end of the programme so that they dry better and can cool down.
•First empty the lower basket, and then the upper rack. By using this procedure you will avoid any water that may be remaining in the upper basket, dripping onto the dishes in the lower basket and leaving water marks.
20