Connect the inlet hose to a water tap with an external thread of 3/4”.
If the water inlet hose is too short, replace the water inlet hose with an applicable, longer
To suit the installation, it is possible to turn the end of the hose that is connected to the dishwasher. Do these steps :
1.Loosen the retaining nut.
2.Turn the hose.
3.Tighten the retaining nut.
Warning! Make sure that the retaining nut and all other connections are tight before you move the dishwasher into position.
Warning! Always use a new water inlet hose. Do not use connection hoses from an old appliance.
Drain hose
The appliance has water safety system to prevent water damage. If there is a malfunc- tion, the drain pump automatically starts to drain the remaining water out of the dish- washer.
Warning! Only if the dishwasher is connected to the mains socket, the water safety system operates when the dishwasher is off.
electrolux 15
2 procedures are possible to install the water drain hose :
1.Attach the plastic curve supplied at the end of the hose.
Put the water drain hose in the sink.
2.Connect the water drain hose to the wa- ter drain system.
The hose must be less than 75 cm above
the bottom of the dishwasher to prevent incorrect operation of appliance.
If you connect the water drain hose to a trap spigot under the sink, remove the plastic membrane (A). If you do not remove the membrane, remaining food can cause a blockage in the drain hose spigot