Electrolux ESL 6251 What to do if, Remedying small malfunc- tions, Short warning tone, continu

What to do if...

Remedying small malfunc- tions

If the acoustic signal is activated, warning tones sound if there are faults.

If one of the following fault codes is displayed in the multi-display during operation:

–Fault codeÅ 10 (Problems with water inlet),

–Fault codeÅ 20 (Problems with water drainage), please have a look at the following table.

When the fault is remedied, press the button for the cycle that has started. The cycle will continue.

With other fault codes (“Å ” followed by a number):

–Abort the dishwashing cycle.

–Switch the appliance off and on again.

–Re-set the dishwashing cycle.

If the fault is displayed again, please contact your lo- cal Service Force Centre and inform them of the fault code.

Malfunction		Possible cause	Remedy
		Water tap is blocked with limescale	Check the tap and have it repaired, if
		or is faulty.	necessary.
		The tap is turned off.	Turn on the tap.
1 short warning tone, continu-
		The filter (where present) in the	Clean the filter in the threaded hose
ously repeated, can be heard,		threaded hose fitting on the tap is
			fitting.
the cycle indicator for the selected		blocked.
wash program is flashing:
			Cancel the dishwashing cycle (see
the control indicator	lights
			chapter: Starting a dishwashing cy-
up:
		Filters in the base of the washing	cle),
fault code Å 10 is displayed in the
			clean filters (see chapter: Cleaning
multi-display:		compartment are blocked.
			the filters),
(Problems with water inlet)
			then start the dishwashing cycle
			again.
		Water supply hose has not been	Check the position of the hose.
		correctly positioned.
2 short warning tones, continu-		The sink outlet is blocked.	Clean the siphon.
ously repeated, can be heard,
the cycle indicator for the selected
dishwashing cycle is flashing,		Water drain hose has not been cor-	Check the position of the hose.
fault code Å 20 is displayed in the
		rectly positioned.
multi-display. (Problems with wa-
ter outflow)
3 short warning tones, continu-			First shut off the water tap, then
ously repeated, can be heard,		The anti-flood system has been
			switch off the appliance and contact
Fault code Å 30 is displayed in		triggered.
			the Customer Care Department.
the multi-display.

26